Ns3702-24p-4s quick start guide p/n 1072834 • rev 00.01 • iss 14jul14.
- 2 - copyright © 2014 united technologies corporation interlogix is part of utc building & industrial systems, inc. A unit of united technologies corporation. All rights reserved. Trademarks and patents the ns3702-24p-4s name and logo are trademarks of united technologies. Other trade names used in...
- 3 - table of contents 1. Package contents...................................................................................................................................................... 4 2. Requirements ...........................................................................................
- 4 - 1. Package contents thank you for purchasing ns3702-24p-4s - 24-port gigabit 802.3at poe+ managed switch. The description of this model is as follows: ns3702-24p-4s 24-port 10/100/1000base-t 802.3at poe + 4-port shared sfp managed switch (440w) “managed switch” mentioned in this quick installa...
- 5 - 2. Requirements workstations running windows xp/2003/vista/7/8/2008, mac os9 or later, linux, unix or other platforms are compatible with tcp/ip protocols. Workstation is installed with ethernet nic (network interface card). Serial port connect (terminal) the above pc is with com port (db9). E...
- 6 - 3. Terminal setup to configure the system, connect a serial cable to a com port on a pc or notebook computer and to serial (console) port of the managed switch. The console port of the managed switch is dce already. So, you can connect the console port directly to the pc without the need of nu...
- 7 - 4. Logon to the console once the terminal has been connected to the device, power on the managed switch and the terminal will display “running testing procedures”. Then, the following message asks for the login username and password. The factory default username and password are admin as the f...
- 8 - 5. Configure ip address the managed switch is shipped with default ip address shown below: ip address: 192.168.0.100 subnet mask: 255.255.255.0 to check the current ip address or create a new ip address for the switch, please use the procedures as follows: show the current ip address 1. On “ns...
- 9 - configuration of ip address 3. On “ns3702-24p-4s # ” prompt, enter the following command and press as shown in figure 5-2. ”ns3702-24p-4s:/ip> setup 192.168.0.101 255.255.255.0 the previous command would apply the following settings for the managed switch. Ip address: 192.168.0.101 subnet mask...
- 10 - 6. Starting web management the following shows how to start up the web management of the managed switch. Note the managed switch is configured through an ethernet connection. Please make sure the manager pc must be set on the same ip subnet address. For exampl e, the defa ult ip addr ess of t...
- 11 - logging in the managed switch 1. Use internet explorer 7.0 or above web browser. Enter ip address http://192.168.0.100 (the factory default ip address or the one that you have just changed in console) to access the web interface. 2. When the following dialog box appears, please enter the defa...
- 12 - if you are not familiar with switch functions or the related parameter, press “help icon” anytime in the web page to get the help description. Now, you can use the web management interface to continue the switch management or manage the switch by console interface. Please refer to the user’s ...
- 13 - changing ip address or forgetting admin password – to reset the ip address to th e default ip address “192.168.0.100” or re set the logi n password to d efault value, press the hard ware reset button on the front panel for over 10 seconds. After the device is rebooted, you can login the manag...
