Summary of TruVision GEL 1070521A
Page 1
Truvision gel 17 in./ 19 in. Vga monitor user manual p/n 1070521a • rev 1.0 • iss 17mar11.
Page 2
Copyright © 2011 utc fire & security company. All rights reserved. Trademarks and patents interlogix, truvision and logos are trademarks of utc fire & security. Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective produc...
Page 3
Interference by one or more of the following measures: • reorient or relocate the receiving antenna. • increase the separation between the equipment and receiver. • connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • consult the dealer or an ex...
Page 4: Content
En 4 user manual content important safeguards 5 introduction 6 product dimensions (mm) 7 operating instructions 7 osd configuration 9 description of the menus 9 specifications 11.
Page 5: Important Safeguards
User manual 5 en important safeguards 1. Installation cautions: • do not block any ventilation openings. • always ensure that the monitor is located in a well-ventilated area to prevent the unit from overheating. • only use accessories specified by the manufacturer or those sold with the product. • ...
Page 6: Introduction
En 6 user manual • always remember to unplug the monitor from the power supply under the following circumstances if the monitor will not be used for a long period of time, if the power supply cable or plug/connector is damaged or if the monitor housing is damaged or broken. Caution: do not attempt t...
Page 7: Product Dimensions (Mm)
User manual 7 en • air bubbles may develop within the glass screen if these recommendations are not observed. Product dimensions (mm) operating instructions figure 1: i/o connectors on the rear panel no. Connector description 1. Vga connect to a rgb input terminal, such as the display card output dv...
Page 8
En 8 user manual figure 2: front panel controls menu in live mode, press to access the osd menus + in menu mode, press to increase the value of the osd menu option selected. In live mode, press to increase volume. - in menu mode, press to decrease the value of the osd menu option selected. In live m...
Page 9: Osd Configuration
User manual 9 en osd configuration configure the monitor using the onscreen display (osd) menus and submenus. Changes are immediately saved and implemented. The menu screen timeouts after 10 seconds and returns to live mode. To change a monitor parameter: 1. Press the menu button on the front panel ...
Page 10
En 10 user manual 6500k: selects normal temperature (comprehensive color). 5800k: selects warm color temperature (yellow bias). Srgb: special application for computer source (r=g=b=128) that setting would be display true color faithfully. User: customizes the red, green and blue gain levels. Exit: r...
Page 11: Specifications
User manual 11 en osd osd h. Pos.: adjusts the horizontal position of the osd area. Setting values range from 0 to 100. Default is 50. Osd v. Pos.: adjusts the vertical position of the osd area. Setting values range from 0 to 100. Default is 50. Osd timer: adjusts the osd appearance time (unit is se...
Page 12
En 12 user manual model 17” 19” viewing angle left 80°/right 80°/ up 80°/down 80° left 85°/right 85°/ up 85°/down 85° response time 5 ms (typ*) input voltage 96 to 256 vac, 60 hz/ 50 hz vga input 15pin d-sub connector x 1 audio input 3.5 mm stereo jack speaker 1 w + 1 w power consumption 35 w operat...