Interlogix TVB-2404 Installation Manual
© 2015 United Technologies Corporation. All rights reserved.
P/N 1072938-EN • REV A • ISS 26MAR15
Interlogix is part of UTC Building & Industrial Systems, a unit of United Technologies Corporation. All rights reserved.
TruVision High Definition TVI Bullet Camera
Installation Guide
Product overview
This is the TruVision High Definition TVI Bullet Camera
Installation Guide for models TVB-2402/TVB-4402 and TVB-
2404/TVB-4404. This guide describes a standard installation.
Package contents:
Camera with power and
video output cables
4 screws and 4 anchors
for wall or ceiling
installation
Back box
Screws M4.8
× 18,
4pcs to attach the back
box
Template
Hex wrench
•
WEEE and Battery
Disposal
CD
Camera description
1. CVBS output cable (black)
2. TVI output cable (grey)
3. Power cable
4. Camera body
5. Sun shield
6. Lens cover
7. Mounting bracket
8. Back box
Note:
Please check the camera output settings before setting up a
system. The TVI video output can be only connected to DVR
with TVI signal input. The CVBS output supports the standard
monitor, test monitor, encoder and DVR.
For TVB-2402 / TVB-4402, the CVBS and TVI output can not
be performed at the same time, you can use the built-in DIP
switch to select the camera video output.
For TVB-2404/TVB-4404, the built-in DIP switch is used to
enable/disable WDR feature, when WDR feature is enabled,
the CVBS output will be blocked out.
DIP switch
Menu button
Installation
To install the camera:
1. Using the template, place it level against the mounting
surface and mark the position of the mounting holes.
2. Following all local codes, drill and prepare the mounting
holes.
3. (Optional) Install the back box on the wall.
4. Route the cables to the cable hole and connect the
corresponding cables. Using a 75-ohm coaxial video
cable, connect the camera TVI video output and a TVI
Ceiling Mounting
1
1
1
1
2
2
2
2
1:Screw Hole for
Bracket
2:Screw Hole for
Mounting Base
8
2
7
3
1
5
6
4
Ceiling Mounting
1
1
1
1
2
2
2
2
1:Screw Hole for
Bracket
2:Screw Hole for
Mounting Base