Interlogix Wireless ShatterPro 5845 Installation Instructions - page 3
Wireless ShatterPro
GND
Green
(NL)
Green
White
Red
Black
Splice white wire from 584509-W to
Green wire from AT&T.
Connect Black wire from 584509-W to
Battery -.
Connect Red wire from 584509-W to
Battery +.
12 position Dip Switch.
#6 to OFF for CL.
#7 to ON for PIR or Glassbreak.
584503-W
ITI 3.5V Learn Mode
Green
(NL)
1. Program the learn mode transmitter
into the MCU.
2. Connect the ShatterPro to the
transmitter as shown.
3. Solder the red lead to the positive
battery terminal on the underside of
the circuit board.
4. Put the cover on the transmitter and
put it back into the back box, snap
the ShatterPro cover in place.
5. Test with Sentrol 5709C Shatterbox
Tester as directed.
584503-W
System VI Transmitter
*If using this transmitter inside the back
box, the circuit board must be removed
from the housing. It can be secured using
the double-stick tape provided. For the
most secure connections, it is better to
solder to the battery connector terminals,
instead of using the “buddy-up” clips.
584509-W
*
AT&T
3-Volt Model 584503-W (shares transmitter battery)
Red to battery +
Black to battery -
White normally open (closes on alarm to battery -)
Green normally closed (to battery -)
Green
White
Red
Black
9-Volt 584509-W (shares transmitter battery)
Red to battery +
Black to battery -
White normally high
Green normally low
Wiring the ShatterPro
3
Red
Black
Green
3.5 V
3.5 V
Black
Red
Green
(NL)
584503-W
ITI 3.5V Programmable
Black
3.5 V
Red
584509-W
Ademco #5716
Black
9 V
Remove battery. Set SW3
#6 down.Set SW4 #1 up.
Do not use magnet.
Connect loop wires
(green). Connect 9-volt
battery terminals. Install
battery, observing polarity.
Red
Green
(NL)
Red
Black
White
(NH)
584509-W
*
Honeywell Model 10-6506 (T-8803)
Red
Black
584503-W
Ademco #5816
3 V
Black
Red
Green
(NL)