Intermatic HA06 Supplementary Manual

           Intermatic, Inc.  Spring Grove, IL  60061   www.intermatic.com           158HA11644 

Thank you for purchasing Intermatic’s HomeSettings devices.  With the HomeSettings program you 

can reliably and remotely control lighting and appliances.   

The outstanding features of the HomeSettings HA06 In-Wall Dimmer Switch include: 

•  Feedback that will allow you to see whether your device has received the ON/OFF/DIM signal.  

•  RF signal reliability – each HomeSettings product has a special feature that virtually 

guarantees that RF signals are received 

•  Ease of installation 

• Manual 

override 

•  Replaces standard indoor wall switches 

•  Use with décor style wall plate (not included) 

•  2-way switching only 

•  Compatible with other Z-wave™ enabled devices

The HA06 In-Wall Dimmer is a Z-wave™ enabled device and is fully compatible with any Home 

Settings network and any Z-wave™ enabled network. Z-wave™ enabled devices displaying the Z-

wave™ logo can also be used with Home Settings modules and controllers regardless of the 

manufacturer, and Home Settings modules and controllers can also be used in other manufacturer’s 

Z-wave™ enabled networks. Each module in a Home Settings network is designed to act as a 

repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended 

destination by routing the signal around obstacles and radio dead spots.

                                                        INSTALLATION                                                                

_

1.  Turn off power to the wall switch circuit at the circuit breaker or remove the appropriate fuse in the 

fuse box. 

2. Install the HA06 In-Wall Dimmer according to Figure 2. Use the provided wire connectors to 

connect the wires from the wallbox to the wires on the HA06. Note:  A minimum load of 40 

Watts is required for the proper operation of this switch. 

3.  Use the provided screws to mount the switch into the wallbox. 

4.  Attach décor style wall plate (not included). 

5.  Turn on power at the circuit breaker or replace the appropriate fuse in the fuse box. 

6.  Before operating the switch, check to make sure that the Air-Gap Switch (see figure 2) is slid to 

the left, into the ON position. A vertical line (ON symbol “|”) can be seen next to the slide switch. 

7.  To manually turn ON the HA06 In-Wall Dimmer, press and release the top half of the wall switch 

paddle. The green indicator LED will turn ON, and the attached light fixture will also turn ON. 

8.  To manually turn OFF the HA06 In-Wall Dimmer, simply press and release the bottom half of the 

wall switch paddle. The green indicator will turn OFF and the attached light fixture will also turn 

OFF. 

9. 

To manually dim the HA06 In-Wall Dimmer, press and hold the Program/ON/OFF/DIM button 

until the desired lighting level has been reached.

For Indoor Use Only

MODEL HA06 

IN-WALL DIMMER