Intermatic PG1000 Series Installation Instructions And Operation Manual
INSTALLATION INSTRUCTIONS
and
OPERATIONS MANUAL
T
URN OFF POWER TO THE ELECTRIC SERVICE OR PANEL AND TO EQUIPMENT TO BE PROTECTED BEFORE
INSTALLING ANY
S
URGE
P
ROTECTION
D
EVICE
. A
LL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRI
-
CIAN AND SHOULD COMPLY WITH THE
N
ATIONAL
E
LECTRIC
C
ODE AND LOCAL ELECTRIC CODES
.
CAUTION:
HARDWIRED SURGE PROTECTION DEVICES
PPGG 2200 - 4400 SSeerriieess
PPGG11000000 - 11550000 SSeerriieess
INSTALLATION:
1.
Test and verify system voltage to assure proper
model selection of Surge Protection Device (SPD).
Refer to the wiring diagrams, configurations and volt-
ages on page 2 for additional information.
2.
Turn Power OFF.
3.
Select a position in the load center or equipment
panel that will require the shortest length of wire lead
for connection. If installing on a breaker panel, the dis-
tance from the main breaker or input lugs to the con-
necting breaker is not as important as maintaining
short wire lead lengths.
4.
Determine the path of the lead wires making sure
to avoid sharp 90 degree bends. Attempt to use 2” or
larger bends.
5.
Remove the knockout from the load center or
equipment panel that best suits positioning of the SPD
for optimum location.
6.
Mount the SPD to the panel or an adjacent wall. If
the mounting position prevents the direct connection of
the nipple to the load center or equipment panel, a
Suitable For Use on a Circuit Capable of Delivering Not More
Than 200,000 rms symmetrical Amperes.
DO NOT OPEN - contains no serviceable parts
INSTALLATION INSTRUCTIONS and OPERATIONS MANUAL
PG20-40 SERIES - V.11-03
short piece of conduit or flexible conduit such as “sealtite” must be used to comply with the National
Electrical Code and local codes.
7.
Twist or ty-wrap lead wires to eliminate any space or gaps between them. Pass the wires
through the selected knockout and secure the SPD.
8.
Cut each wire lead to the proper length. DO NOT coil extra wire length.
Model PG40-480-3D
Other models and voltage configurations
will appear slightly different