Intermec 6300 SERIES Programmer's Reference Manual - Return Value
Component Reference
SECTION 3
3-6 DOS Signature Capture Utility Programmer’s Reference Guide
-p printerĆtype:
Selects the printer type. Valid values for printerĆtype
are 4810", 4815", 4820", 6805", and 6820" (deĆ
fault). The values 4815", 4820", and 6820" produce
identical output files.
-v
Verbose mode. Displays status messages.
Return Value
Return values 0-66 indicate success. For printer types
4815," 4820," and 6820," this value is the number of
print lines needed to print the image, based on a line spacĆ
ing factor of six lines per inch. A value of 66 means that
the image takes 66 or more print lines. This value can be
used by the calling application to determine if a formfeed is
needed to avoid printing the image across a page perforaĆ
tion. For other printer types, this value is always zero.
Return values greater than 66 indicate error conditions.
The following values are defined:
Value
Meaning
251
Cannot open output file.
252
Cannot access .PCX file.
253
An error occured while writing output file. One
possible cause is that the width of the image
exceeds the capability of the printer.
254
Out of memory. Unable to allocate memory.
255
An invalid or missing command line parameter
encountered, or -? specified.
Usage Notes
If the output file exists when this program is called, the
print data is appended to the file.
The output file is not deleted if an error occurs. The calling
application must delete this file.