Intermec IP3 Intellitag Instructions - Lightpipe Installation
Lightpipe Installation
1
Remove the backing from the adhesive on the Lightpipe
assembly.
2
Position the lower end of the Lightpipe into the angled recess
of the Reader.
3
Align the upper end with the molded feature in the Reader so
that the edge of the Lightpipe fits squarely across the edge of
the molded feature.
4
Press firmly into place and hold for a few seconds to allow the
adhesive to set.
Note: It is very important that the new Lightpipe is
positioned exactly as shown in the following illustra-
tion. This helps ensure proper reflecting of the Infrared
signals between your mobile device and your reader.
Adhesive backing
Lightpipe in proper
position
Molded feature
8PSMEXJEF)FBERVBSUFST
UI"WFOVF8FTU
&WFSFUU 8BTIJOHUPO64"
UFM
XXXJOUFSNFDDPN
ª*OUFSNFD5FDIOPMPHJFT
$PSQPSBUJPO"MMSJHIUTSFTFSWFE
*1*13FBEFS-JHIUQJQF*OTUSVDUJPOT
1/