April 28th, 2016 printed in canada instruction manual 490, rue de l'argon québec, canada g2n 2c9 tél.: 418-849-8095 fax : 418-849-0077 www.Jaroby.Com certified and tested according to can /ulc s627-00 ul 1482-2011 2020 u.S. Environmental protection agency's crib wood emission standard product # 10-0...
April 28th, 2016 table of contents introduction ............................................................................... 3 listing and code approvals ....................................................... 3 appliance certification. ..................................................... 3 mobi...
April 28th, 2016 3 introduction this manual describe operation and installation of j. A roby woodstove model: polaris, centauri, antares, sirius, rigel, and vega. This appliance respond to 2020 us environment protection with sized controlled crib wood. This appliance delivered from 11000 btu/h to 27...
April 28th, 2016 4 nameplate.
April 28th, 2016 5 appliance dimension 33.0" 83.9cm 25.2" 63.9cm 25.5" 64.8cm 41.3" 105.0cm 14.1" 35.7cm 11.0" 28.0cm specifications clearances to combustible material option centauri, polaris, sirius, rigel vega, antares combustible wood wood wood recommended surface area 1800 ft 1800 ft² 1800 ft c...
April 28th, 2016 6 installation fire safety to provide reasonable fire safety, the following should be given serious consideration: 1. Install at least one smoke detector on each floor of your home to ensure your safety. They should be located away from the heating appliance and close to the sleepin...
April 28th, 2016 7 minimums clearances to combustible material with these reduced clearances, this appliance take a minimum of space where is installed. Whether in the living room or the dining room, the stove will complete your decorate by his originality and heating, it requires a minimum clearanc...
April 28th, 2016 8 assembly before installation according to chosen option, to save more storage space and shipping. The stove leg couldn’t be assembled in the shop, you must assembly before install the stove. Legs installation 1) remove legs and bricks from combustion chamber to lighten the stove. ...
April 28th, 2016 9 warning: never route power cord under or in front of the apliance warmer stove assembly (optional). Now, you need to know which type of smoke pipe: smoke simple pipe or smoke double pipe. For the smoke simple pipe: it’s not necessary to remove the pre- cut metal part. For the smok...
April 28th, 2016 10 5) fix the top with the back and with the front too. 6) fix the left decorative panel side and finish to install the left chrome decoration 7) fix the right decorative panel side and finish to install the right chrome decoration..
April 28th, 2016 11 8) put and fix the warmer with the 6 holes of each side to the cook stove. Firebricks installation side firebricks installation 1) put 4 bricks "a" and 2 brick "b" back firebricks installation 1) put 3 bricks «a» and 1 brick «c» on the back wall. Floor firebricks installation 1) ...
April 28th, 2016 12 firebricks installation on the pipes the firebricks must be put on the 3 pipes from the front of combustion chamber. Bricks keep a maximum of heat inside the combustion chamber and help the air ratio to burn the most of wood pollution gas made by wood steam and wet wood. Put the ...
April 28th, 2016 13 general stove installation steps location considerations. • we recommend installation of this appliance by a certified installer consideration must be given to: • safety • traffic flow • convenience • chimney and chimney connector required • draft plan your installation on paper ...
April 28th, 2016 14 chimney connector installation the chimney connector is a set of single wall or double wall flue pipes and elbow installed between the stove collar and the chimney collar. The single wall chimney connector is sold into any hardware store and are not homologated and certified. Som...
April 28th, 2016 15 mobile home installation danger: do not install in bedroom. Warning: the structural integrity of the mobile home floor, wall, and ceiling/roof must be maintained. Vapor barrier efficacity must be keept in good condition 1) do the general stove installation steps 1 to 11. 2) the f...
April 28th, 2016 16 chimney installation, general steps use only approved chimneys. The same size as the output collar. 6 inches in this case. The chimneys used must be tested according to can/ulc s629 m87 in canada and to ul 103 (type ht) in usa. The stove can be install with a masonry chimney acco...
April 28th, 2016 17 inside masonry chimney, vertical installation the wood appliance must be installed in accordance with the applicable local laws or the can/csa-b365, nfpa211 (usa) norms. Follow the chimney manufacturer’s instructions to install the chimney. The chimney masonry must have inside a ...
April 28th, 2016 18 cathedral vertical installation the wood appliance must be installed in accordance with the applicable local laws or the can/csa-b365, nfpa211 (usa) norms. Follow the chimney manufacturer’s instructions to install the chimney. Always pass chimney between joists. If a joist need t...
April 28th, 2016 19 vertical installation the wood appliance must be installed in accordance with the applicable local laws or the can/csa-b365, nfpa211 (usa) norms. Follow the chimney manufacturer’s instructions to install the chimney. Always pass chimney between joists. If a joist need to be cut, ...
April 28th, 2016 20 external combustion air source in conventional designed house, natural ventilation is enough to operate the wood stove. In some new energy saving house, natural ventilation is not enough to good operation of your stove. To avoid reverse circulation of smoke caused by negative pre...
April 28th, 2016 21 to ensure proper tubes orientation, a groove is cut at one end of tubes, and a corresponding emboss is cut into the hot air side channel. Step to install a tube. 1) insert the tube into the round hole into the hot air side channel. 2) align and insert the groove into the other si...
April 28th, 2016 22 4) once you have an ember fire, it’s time to add logs. Follow now the instruction section on how to keep a fire do not over charge the stove over the upper brick row you can control the combustion by turning up or down the handle. The wood will burn more rapidly when more primary...
April 28th, 2016 23 (4) materials containing plastic; (5) waste petroleum products, paints or paint thinners, or asphalt products; (6) materials containing asbestos; (7) construction or demolition debris; (8) railroad ties or pressure-treated wood; (9) manure or animal remains; (10) salt water drift...
April 28th, 2016 24 chimney inspection wood moisture, wood species, the combustion quality, are some factors that can influence creosote buildup speed into chimney and chimney connector. The chimney and the chimney connector must be inspected at least one every two month during the warming season or...
April 28th, 2016 25 fiberglass rope replacement use a ½ inches (12.7mm) braided fiberglass rope. It is possible to replace the braided fiberglass rope with the door on the stove, but if you want you can remove door. Fiberglass rope preparation 1) take the end of the fiberglass rope and push fiber in...
April 28th, 2016 26 appendix 1 door assembly square door.
April 28th, 2016 27 arc door.
April 28th, 2016 28 appendix 2 fans electric wiring diagram therm-o-disk box parts description.
April 28th, 2016 29 appendix 3 parts that can be replaced • bricks • doors glass • spring handle • stove door with handle • fans • flat fiber glass rope (around glass) • round fiberglass rope • ash plug • slotted brick washer to ordered parts call your stove seller representative..
April 28th, 2016 30 appendix 4 bricks dimension and quantity..
April 28th, 2016 31 j. A. Roby limited life warranty wood burning stoves & fireplaces j. A. Roby’s warranty only applies to original buyer and is non-transferable. This warranty covers brand new products only, which have not been altered, modified nor repaired since shipment from factory. The produc...
