J. A. Roby JUNIOR 8" Oil1 Owner's Manual

Manual is about: OIL STOVE

Summary of JUNIOR 8" Oil1

  • Page 1

    490, rue de l'argon québec (québec) g2n 2c9 phone.: 418-849-8095 fax : 418-849-0077 www.Jaroby.Com owner’s manual junior oil stove september 4 th , 2007 review junior oil stove certified and tested according to can/csa 140.3 & ul 896.

  • Page 2: Contents

    2 contents characteristics .............................................. Erreur ! Signet non defini. Warning ........................................................................................................................ 5 appliance parts ......................................................

  • Page 3: Features

    3 features junior 8'' oil #1 oil #2 minimum consumption, cc/min. (l/h) 6.6 (0.4) 9.4 (0.56) maximum consumption, cc/min. (l/h) 20.5 (1.23) 20.0 (1.2) draught, w.C. (mm w.C.) 0.04 (1.0) 0.05 (1.3) power of entry, minimum consumption, btu/h 14 200 20 800 power of entry, maximum consumption, btu/h 44 1...

  • Page 4

    4 clearances (junior 8'' and junior 10'') floor combustible lateral wall (left or right) 8'' (203 mm) opposite wall 36'' (914 mm) back wall 10'' (254 mm) front 36'' (914 mm) above 36'' (914 mm) simple wall conduit 9'' (229 mm).

  • Page 5: Warning

    Warning before the installation, please take a few minutes to read carefully this handbook. Keep it in a sure place and easily reachable for future references. If this appliance is not properly installed, it could cause fire damages to the property, injuries and death. To reduce fire hazards, follow...

  • Page 6: Appliance Parts

    6 appliance parts figure 1.

  • Page 7

    7 d etails 1. C arburetor : controls oil flow to the burner. 2. C leaning rod : make it turn to clean oil supply conduct to the burner. To use regularly. (do not pull) 3. B urner : where combustion takes place. Ensures air supply. 4. C atalyst : regularises combustion. To be placed in the center of ...

  • Page 8: Stove Location

    8 stove location you have just acquired a j.A. Roby inc. Oil stove. The choice concerning the location of your j.A. Roby inc. Stove is the key to an efficient, safe and easy use of your new appliance. Your stove should be installed in a strategic and central place in order to facilitate the heating ...

  • Page 9: Chimneys

    9 chimneys the oil stove you just acquired has been highly tested in order to ensure its operation and efficiency. However, the appliance remains dependent of exterior factors such as fuel supply and chimneys. Chimney draught is essentially caused by the fact that hot gases emitted by the appliance ...

  • Page 10: Connection To The Chimney

    10 connection to the chimney before connecting the stove to the chimney, you must be sure of the following : - chimney to which the appliance will be connected is clean, of appropriate dimensions and in a good condition of operation. - chimney section that overhangs the roof should be of a sufficien...

  • Page 11: Oil Connection

    11 oil connection figure 4 the oil alimentation system consists in a closed steel tank provided with a filling cap, an oil gauge and a hole at its bottom. The oil tank must be higher than the carburetor in order to get a gravity oil supply. A. Filling cap b. Oil gauge c. Oil tank must be well fixed ...

  • Page 12: Starting

    12 starting a technician should do the first lighting before proceeding to the first lighting, make sure that all parts are in place (figure 1), that the connection to the chimney is secure and that all oil supply conduct joints are tight. 1. Push down the on/off switch to on. 2. Turn the control bu...

  • Page 13

    13 carburetor adjustments (by a technician) since the carburetor has been adjusted at the manufacture, only small adjustments are necessary and only in particular cases. However, if adjustments are needed, a competent technician should accomplish it. A djusting the minimum flow place control button ...

  • Page 14: Fans And Thermodisc

    14 fans and thermodisc figure 5 f ans t hermodisc 1. Place 4 screws at the grill extremities. 4. Fix the thermodisc box 2. Screw the grill onto the fans. With 2 screws 3. Fix it onto the back of the stove..

  • Page 15

    15 preventive measures and maintenance j.A.Roby’s oil stove does not require a lot of maintenance. Every month, clean up oil supply conduct to burner by activating the cleaning rod (see figure1). To clean up the glass, j.A.Roby recommends using products specially made for such work or an oven cleane...

  • Page 16: Limited Life Warranty

    16 limited life warranty j.A. Roby inc. Warrants for life (following conditions written in the present manual) its high quality appliances against all manufacturing defectiveness. This warranty is only valid for the first buyer of the appliance with a purchase proof and the serial number of the appl...