J-Line Quattro Lite Instruction Manual - page 12
12
QUATTRO LITE MANUAL
SERVO REVERSING
After radio installation, it is imperative that
the proper servo/control system direction be
established. Servo reversing allows you to alter
the direction of the servo/control surface movement
to match the direction of the transmitter stick.
Please refer to the chart in the following section
below to determine the proper control sur-
face direction.
SETTING REVERSING SWITCHES
1. Connect all control linkages and check to see
that all servos move freely.
2. While standing directly behind the airplane, go
through the steps shown in the charts below to
check proper direction of the control surface.
3. Using the servo reversing switches located
behind the transmitter battery case, adjust the
direction of each servo for proper operation.
9.2
9.3
Left
Rudder
Full Throttle
Down Elevator
Right
Aileron/
Rudder
Up Elevator
Left
Aileron/
Rudder
Idle
Right
Rudder
Full Throttle
Left
Rudder
Idle
Right
Rudder
Down Elevator
Right
Aileron/
Rudder
Left
Aileron/
Rudder
Up Elevator
Rudder
Elevator
Aileron
Throttle
Servo Reversing Switches
(Located behind Transmitter Battery Case)
(Mode II Transmitter Shown)
Elevator
Aileron Up
Aileron Down
Rudder
Up Elevator
Throttle
Right Aileron
Right Rudder
(Aileron & Rudder Channel)
or
High
Low
Aileron Channel
Rudder Channel
JRP4477.46 Update Quattro 1/29/01 4:20 PM Page 12