Bluetooth helmet headset bt-03 series © 2017 j&m corporation . All rights reserved. 1/17 installation & operation instructions.
1. Product description j&m’s bt-03 elite & performance series bluetooth headsets are designed for installation into most modular flip-up, open-face, full- face and shorty- style helmets, using specific designated models. The audio performance of j&m’s elite series bluetooth headsets will rival that ...
4. Controls and functions a. Volume down – controls step-down volume adjustment from the linked source, by press- ing once momentarily for each step of volume reduction. Press and hold for 2 seconds to track-up to the next music track. B. Volume up – controls step-up volume adjust- ment from the lin...
J&m bt-03 series helmet headset installation instructions warning! Helmet speakers may not be legal in all jurisdictions. Check your local laws before using this product. J & m corporation cannot control the circumstances surrounding the sale of this equipment, the quality of installation, or the sp...
J&m bt-03 series helmet headset installation instructions warning! Helmet speakers may not be legal in all jurisdictions. Check your local laws before using this product. J & m corporation cannot control the circumstances surrounding the sale of this equipment, the quality of installation, or the sp...
Using an exacto® knife, cut out a hole of sufficient size to allow the microphone to be mounted through the nose section and be pressed against the inside shell. See figure 3. Insert the microphone cartridge through the hole from the back side, install the rubber boot and push the mike back into the...
J&m bt-03 series helmet headset installation instructions warning! Helmet speakers may not be legal in all jurisdictions. Check your local laws before using this product. J & m corporation cannot control the circumstances surrounding the sale of this equipment, the quality of installation, or the sp...
1. To charge the unit, plug the supplied usb charge/data cable into the charge port (d). The red led will turn on to indicate that the battery is charging. The red led will turn off when the battery is fully charged and ready for use. The charger can also be left plugged into the unit for extended p...
Pairing and operation of the bt-03 headsets in helmet-to- helmet intercom mode. (up to 4 total) 1. Press and hold intercom/search mode button (c) and multifunction but- ton (f) together until all headsets in the group turn on. 2. Put bt-03 #1 into intercom linking mode by depressing & holding the mu...
Warranty registration form please fill out this card completely and mail it immediately after purchase. Please be sure that your zip code and serial number (if applicable) are legible. This will help us to serve you better. (please print) name ________________________________________________________...
