? 20 17 j&m cor poration. All rights reser ved. 7/1 7 rokker ® xxr 330w bluetooth® controlled amplifier kit for 1998-2017 harley® roadking # jamp-330rk14-blu installation instructions.
Installation and instructions 1. Remove the headlight, ignition switch cover, seat, fuel tank, both saddlebags and both plastic frame side covers to basically strip the roadking down for audio system install. (photo-a) product description this exciting new j&m 330w bluetooth controlled amplifier kit...
4. Then route the forward part of this harness under the frame crossmember in front of the battery, up into the plastic wire harness holder (that runs all the way up to the fork-neck) forward all the way to a position inside the headlight housing. (photo-d) 5. Push the fuse block back into the frame...
9. Then route the cable from the bluetooth controller down the handlebar to the connection location inside the headlight housing and plug-in the corresponding plugs from the j&m and harley wiring harnesses inside the headlight housing. (photo-h) at this same time, plug-in or wire-in (depending upon ...
14. Place the left-side saddlebag on the padded bench to protect. Cut out template #4 from the instruction manual for the 2014-2017 harley saddlebag, or template #2 for the 1998-2013 harley saddle- bag. Hold it up against the inside of the left saddlebag and mark the oval opening to be drilled/cut i...
18. Now connect all wire plugs and connections to the amplifier, us- ing the interchangeable amplifier plug harness “a” if you will be using only two saddlebag lid speakers, or amplifier plug harness “b” if you will be connecting 4-speakers to the system. (photo-r) 19. Wrap both rca-rca connections ...
Drill 53/64” dia. Hole 13/64” drill 13/64” drill template 1: for 1998 - 2013 harley right saddlebag - grommet hole cut out. (place over existing attachment rubber grommet) top inside of saddlebag template 2: for 1998 - 2013 harley left saddlebag - amplifier plug top inside of saddlebag cut out, mark...
(blank page).
Drill 53/64” dia. Hole 13/64” drill 13/64” drill template 3: for 2014 - 2017 harley right saddlebag - grommet hole cut out. (place over existing attachment rubber grommet and hardware) template 4: for 2014 - 2017 harley left saddlebag - amplifier plug cut out. (place over existing attachment rubber ...
(blank page).
Warranty registration form please fill out this card completely and mail it immediately after purchase. Please be sure that your zip code and serial number (if applicable) are legible. This will help us to serve you better. (please print) name ________________________________________________________...
