J&M Corporation STAGE-4 ROKKER XXR Custom Installation instructions - page 3
stud on the frame that the negative battery cable is connected to.
(Fig. A)
Then reconnect the negative battery cable to the battery. (Figure A)
Do not connect the negative (black) lead from the amplifier to the
negative post of the battery.
4. Disconnect all plugs from the rear of the radio and then
remove the radio itself by removing four mounting bolts. (Fig. B)
5. Place the amplifier into the fairing upside down with the
power/ground cable (Red and Black wires) facing towards rear of
the bike.
6. Connect the amplifier main wiring harness to the amp before
securing to the mounting bracket. Center the amp into position,
place top bracket with J&M Logo facing up, align the screw holes
and insert the four supplied screws and tighten securely. (Fig. C)
7. Connect the main power cable and tuck wire down on the
side of the amplifier so as not to interfere with the radio as it is
reinstalled. Connect the RCA input harness to the amplifier.
8. Make Amplifier/Speaker connections as per diagram. (Fig. D)
9. Re-install the factory radio.
10. Test the system for proper operation before reassembling the
fairing, realizing that full sound quality and fidelity will not be heard
until the outer fairing shell is completely reinstalled.
Speaker
Enclosure
Speaker
Enclosure
Remove
2-pin
12v plug
Connection to Amp
Fig. B
BATT
+
Red
Black
Master Frame
Grounding Stud
Fuse
Heavy Gauge
Amplifier Power/
Ground Wire Harness
Negative
Battery Cable
Fig. A