J. Perkins F/A 18E Super Hornet Instruction Manual - page 10
10
35. Select
PROG.MIX1 from the radio menu.
Set the mix for
ELEV to FLAP. Make sure
that the rates are both at -100% and that
the switch is set to
MIX. There should be
no offset for this mix.
36. Select
PROG.MIX2 from the radio menu.
Set the mix for
ELEV to AUX2. Make sure
that the rates are both at +100% and that
the switch is set to
MIX. There should be
no offset for this mix.
37. Select
PROG.MIX3 from the radio menu.
Set the mix for
AILE to FLAP. Make sure
that the rates are both at -100% and that
the switch is set to
ON. There should be
no offset for this mix.
38. Select
PROG.MIX4 from the radio menu.
Set the mix for
AILE to AUX2. Make sure
that the rates are both at -100% and that
the switch is set to
ON. There should be
no offset for this mix.
39. On
LOW RATES the Ailerons should
move
1/2” in both directions. The Thrust
Vector units should move in the same
direction as the Ailerons.
NOTE: When the Ailerons are in their neutral
position the Thrust Vector Nozzles should be
in their neutral positions also. If they are not
you must adjust them mechanically by screw-
ing or unscrewing the ball link connector to
achieve a neutral position.