J. Perkins Nano Stik Instruction Manual

Summary of Nano Stik

  • Page 1

    Specifications wingspan 12.4ins (315mm) length 10.6ins (270mm) weight with battery 0.3oz (9g) battery 30mah 1s 3.7v lipo (included) charger 1s 3.7v lipo (in transmitter, included) transmitter 3ch 2.4ghz w/lipo charger (included) on-board electronics 2-in-1 receiver/esc and magnet instruction manual ...

  • Page 2

    Guarantee/warranty j. Perkins distribution ltd. Guarantee this product to be free of manufacturing and assembly defects for a period of one year from time of purchase. This does not affect your statutory rights. This warranty is not valid for any damage or subsequent damage arising as a result of a ...

  • Page 3

    Introduction weighing in at only 9 grams ready to fly – about 1/4 the weight of typical ultra-micro class models – the nano stik is a great choice when looking for a lightweight aeroplane to fly indoors in more places than ever before. The nano-micro size and weight allows for slow and easy flying e...

  • Page 4

    Items included with your model: transmitter aa batteries (4) assembled aircraft li-po battery usb charge lead install the transmitter batteries open the rear cover of the transmitter. Insert the four aa batteries noting the polarity of the batteries molded into the transmitter case. Replace the cove...

  • Page 5

    Binding the model your model is shipped ready to fly. If you find the controls are not responding to the transmitter, it may be necessary to bind the radio system. Use the following to bind the radio system. 1. Turn on the transmitter 2. Install the flight battery and connect the plug 3. Press and h...

  • Page 6

    Flying your model your model has been designed for the intermediate modeller who is familiar with the use of a 3-channel radio system. Always perform a range and flight check to make sure all controls are operating properly before flying your model. Flight check: point the model into the wind. Advan...

  • Page 7

    Trimming the model in flight if you find that your model does not fly straight, it may be necessary to adjust the trim for straight and level flight. Trimming is best done when flying at 1/2 to 2/3 power. Rudder trim if the model appears to turn slightly to the right or left, it may be required to a...

  • Page 8

    Adjusting the wing position and centre of gravity it’s possible to adjust the position of the wing and center of gravity (cg) to fine-tune the overall flight performance and handling of the nano stik in various flying areas and conditions. For example, moving the wing forward/toward the front of the...

  • Page 9

    Safety instructions for charging and using li-poly batteries • do not put the battery on, or near anything, that can catch fire when charging. • always charge the battery on a non-flammable base, i.E. A metal tray. • do not disassemble the battery. • do not short-circuit the battery. • do not use, o...

  • Page 12

    J perkins distribution, lenham, uk www.Jperkinsdistribution.Co.Uk.