Assembly and operating manual explorer prop specification: *length: 27‐1/2"(698mm) *wing span: 55‐1/10"(1400mm） *flying weight: 400g(14‐1/10oz.).
Assembly and operating manual explorer prop 2 dear customer, congratulations on your choice of a factory-assembled model aircraft from the skyangel range and thank you for placing your trust in us. Very little preparation work is required to get this model ready to fly. To operate your new model saf...
Assembly and operating manual explorer prop 3 fig. 1 -assemble the v-tail fig. 2 - install v-tail on fuselage, fig. 3 -photo shows the finished view fig. 4 - lock the v-tail with screws 1 2 4 3.
Assembly and operating manual explorer prop 4 fig. 5 -connect the control rods and control horns . Fig. 6 - assemble the control rods to the servo .And connect the rods with servo arms and control horns. Fig. 7 - put the servo cover on the wings . Fig. 8 - photo shows the cover on the servo . . 5 6 ...
Assembly and operating manual explorer prop 5 fig. 9 -install the wing support bar into the main wings fig.10 -lock the main wings with screws. Fig. 11 -connect the channel wire leads to the receiver fig. 12 - located the battery 9 10 11 12.
Assembly and operating manual explorer prop 6 fig fig. 13 - connect the battery and esc fig. 14 - congratulations, you have completed the assembly process. We hope you enjoy flying your new model! Fig. 15 photo shows the balancing weight. - place the canopy on the fuselage. - place the battery in th...
Assembly and operating manual explorer prop 7 fig. 16 - charge the flight battery; connect the equalizer lead using and adapter lead matching your charger (adapter lead not included). -controller and then switch the transmitter off. Fig. 17 - switch the transmitter on, and move the throttle stick to...
Assembly and operating manual explorer prop 8 fig. 18 function test - check the channel assignment at the receiver, and if necessary swap the plugs as necessary. - set the transmitter sticks and trims to centre. - the control surfaces should now also be at centre (neutral). Adjust the clevis where n...
Assembly and operating manual explorer prop 9 - switch the transmitter on, and connect the flight pack - check the direction of rotation of the motor: when viewed from the front, the output shaft must rotate anti-clockwise. If this is not the case, perhaps because you are using components other than...
J-power group co.,ltd 5th floor, a3 building, xinjianxing technology industrial park, fengxin road, guangming town, bao'an, shenzhen city, 518107 china phone: +86 755 33699201 fax: +86 755 33699203 www.Jpower.Hk.
