Assembly and operating manual katana specification: *length: 27‐1/5"(690 mm) *wing span: 23‐3/5"(600 mm) *flying weight: 12‐7/10 oz (360g).
Assembly and operating manual katana 2 dear customer, congratulations on your choice of a factory-assembled model aircraft from the jpower range and thank you for placing your trust in us. Very little preparation work is required to get this model ready to fly. To operate your new model safely it is...
Assembly and operating manual katana 3 fig. 1 -apply glue to wing set. Fig. 2 -install wing set on fuselage, photo shows the finished view . Fig. 3 - glue horizon tail to fuselage. Fig. 4 -photo shows the finished view. 1 2 4 3.
Assembly and operating manual katana 4 fig. 5 - glue vertical tail to fuselage. Fig. 6 - photo shows the finished view . Fig. 7 -locked control horns with screws. Fig. 8 -connect the electronic speed controller and servos to the receiver. Refer to the radio instructions for the correct channel socke...
Assembly and operating manual katana 5 fig. 9 - locate the battery and canopy. Charge the battery according to the safety instructions before installing. Fig.10 -turn on the transmitter ,put the throttle to the lowest position .Connect battery and esc fig. 11-12 checking ailerons - check that the co...
Assembly and operating manual katana 6 fig fig. 13-14 checking elevators -move the elevator stick down, and the elevator(a) must rise up, move the elevator stick up ,the elevator (b) fall down. Fig. 15-16 checking rudder -move the rudder stick to the left (a), and the rudder direction (a) must left,...
Assembly and operating manual katana 7 fig. 17 checking the power system -hold the model securely. -remove any loose objects such as cloths, tools,etc from the area in front of the model, as they could easily be sucked into the ducted fan. -open the throttle (stick forward): the motor should now run...
Assembly and operating manual katana 8 fig. 19 checking the models balance -place the flight battery in its compartment, without connecting. -mark the centre of gravity (cg) on both sides of the fuselage; the position is shown in the photo. -support the model at the marked points and allow it to han...
Assembly and operating manual katana 9 - switch the transmitter on, and connect the flight pack - check the direction of rotation of the motor: when viewed from the front, the output shaft must rotate anti-clockwise. If this is not the case, perhaps because you are using components other than those ...
J-power group co.,ltd 5th floor, a3 building, xinjianxing technology industrial park, fengxin road, guangming town, bao'an, shenzhen city, 518107 china phone: +86 755 33699201 fax: +86 755 33699203 www.Jpower.Hk.
