J-Power Nano warbirds FW-190 Assembly And Operating Manual - page 13
Assembly and Operating Manual Nano
warbirds
fw-190
13
Fig.40
- Switch the transmitter on, and move the throttle
stick to the “Motor OFF” position. (Diagram MODE
1 right throttle control stick)
Fig.41 and 42
- Check the channel assignment of the control
surfaces, and swap over the connectors at the
- Check the neutral position of the control surfaces.
Make adjustments to the clevises if necessary.
- Stand behind the model.
- Check the direction of rotation of the servos.
- When you move the aileron stick to the right (a),
the right-hand aileron (a) should rise, the left-hand
aileron (b) fall.
-
- Pull the elevator stick back towards you (c), and
the rear edge of both elevators should rise (c).
- If either control surface function works the wrong
way round, correct it using your transmitter’s servo
reverse facility for that function.
- Check that all the linkages are firmly fixed, but
free-moving.
- We recommend that you set around 50% Expo on
42
40
41