J. W. Davis & Company DA-120M User Manual - page 5
The Mark of the Professional...
NEW TECHNOLOGY
OLD RELIABILITY
J.W. Davis & Company
3030 Canton Street • P.O. Box 710219 • Dallas, Texas 75371-0219
Sales 800-527-5705 • Fax 800-388-9106 • Corp 214-651-7341 • Fax 214-939-0328 • sales@jwd.com • www.jwd.com
•
IV - BACK PANEL DETAIL
5
(9) Input 2 XLR input jack accepts balanced low impedance signal from microphones, mixers, wireless micro-
phone receivers and equipment with compatible signals. The input is rated at 150
Ω, 1mV.
INPUT 2
(2) Input 4 terminal strip input accepts balanced low Impedance signal from microphones, mixers, wireless
microphone receivers and equipment with compatible signals. The input is rated at 150
Ω, 1mV.
(3) Input 4 dip switch allows four selections: auxillary (AUX), screw terminal (T), XLR-F (J) and 17VDC phantom
power (PHANTOM)
.
Input 4 XLR input jack accepts balanced low impedance signal from microphones, mixers, wireless micro-
phone receivers and equipment with compatible signals. The input is rated at 150
Ω, 1mV.
(1)
INPUT 4
(7) Input 3 terminal strip input accepts balanced low impedance signal from microphones, mixers, wireless
microphone receivers and equipment with compatible signals. The input is rated at 150
Ω, 1mV.
(8) Input 3 XLR input jack accepts balanced low impedance signal from microphones, mixers, wireless micro-
phone receivers and equipment with compatible signals. The input is rated at 150
Ω, 1mV.
(6) Input 3 dip switch allows four selections: auxillary (AUX), screw terminal (T),
XLR-F (J) and 17VDC phantom power (PHANTOM).
(5) Input 3 features two RCA jacks that electronically combine stereo or two-
channel audio for a mono signal. To input a single mono signal, either RCA
jack may be used. The input is rated at 47k
Ω at 100mV.
INPUT 3
(4) Input 4 features two RCA jacks that electronically combine stereo or two-
channel audio into a mono signal. To input a single mono signal, either RCA
jack may be used. The input is rated at 47k
Ω at 100mV.
(10) Input 2 terminal strip input accepts balanced low impedance signal from microphones, mixers, wireless
microphone receivers and equipment with compatible signals. The input is rated at 150
Ω, 1mV.
(11) Input 2 dip switch allows four selections: auxillary (AUX), screw terminal (T), XLR-F (J) and 17VDC phantom
power (PHANTOM).
NOTE:
Only one input
on the dip switch (Micro-
phone XLR, Microphone
Screw Terminal or Auxil-
iary) should be selected
at any given time. Se-
lecting more than one
input will cause a distor-
tion and a drop in the in-
put signal.
(12) Input 2 features two RCA jacks that electronically combine stereo or two-channel audio into a mono signal.
To input a single mono signal, either RCA jack may be used. The input is rated at 47k
Ω at 100mV.