J. W. Davis & Company DMC-16 User Manual - page 6
Microphone Line Channels
Repeat the above steps for channels 2 through 8 on the console.
14.
Press the PFL switch for channel 1 to disengage the switch.
13.
If adjusting EQ, repeat step 11.
12.
Adjust the TRIM control so that the LED meter indicates approximately -4dB with transient
peaks not exceeding 0dB.
11.
Plug a microphone into channel 1 MIC input.
1.
Turn on the mixer POWER switch located on the back pannel.
2.
Slide the Channel Fader Control to unity gain 0dB.
3.
Slide all other Channel Fader Controls down to the infinity “
∞
∞
∞
∞
∞
” position.
4.
Set TRIM control fully counter-clockwise.
5.
Set the three EQ controls (HIGH , MID , LOW , at the center detent position (12 o’clock).
6.
Bring MASTER MIX volume control down to the infinity “
∞
∞
∞
∞
∞
” position.
7.
Push in the PFL switch for channel 1.
8.
Push in the MASTER/PFL TO CONTROL ROOM switch in the output section. (The lower
LED’S should light.)
9.
Generate a signal by speaking or singing into the microphone.
10.
The Mark of the Professional...
NEW TECHNOLOGY
OLD RELIABILITY
J.W. Davis & Company
• 3030 Canton Street • P.O. Box 710219 • Dallas, Texas 75371-0219
Sales 800-527-5705 • Fax 800-388-9106 • Corp 214-651-7341 • Fax 214-939-0328 • sales@jwd.com • www.jwd.com
PRACTICE SETUP PROCEDURE
This procedure is referenced to the front and back views of the mixer cabinet on page 5 with the bracketed
numbers corresponding to similar bracketed numbers. The first column shown is a replica of the eight mono
channels (“LINE 1” through ”LINE 8”). The second column is a replica of the four stereo channels (“LINE 9-
10” through “LINE 15-16”). The third column is a replica of the Master Control section. The bottom drawing is
an abbreviated view of the back of the mixer.
4
5
15.
Stereo Line Channels
Slide the MASTER MIX faderto approximately -20dB, and you have set up your mixer.
22.
Generate a signal source by connecting a tape player, keyboard or similar equipment into chan-
nels 9-10 .
17.
20.
After all channels are set at unity gain (0dB), push in the MASTER/PFL TO CONTROL ROOM
switch to disengage the MASTER/PFL TO CONTROL ROOM switch.
21.
18. The LED meter should indicate approximately -4dB with transient peaks not exceeding 0dB. The
stereo inputs are fixed at the above setting. If source has output adjustment, adjust to achieve the
above setting.
Push in PFL switch for channels 9-10 .
16.
If adjusting EQ, repeat step 18.
19.
Slide Channel Fader Control for channels 9-10 to the 0dB mark.
Repeat steps 15 through 19 for channels 11-12, 13-14 and 15-16.
34
13
5
7
6
23
12
17
22
22
4
12
28
28
28
12
17
23
13