Jabra 2013-02-05 - 2010 ST Monaural Headset User Manual - page 6
5
EN
g
Li
Sh
JABrA BT2010 BlUeTOOTh heADSeT
Pleasenote:Thelifetimeofthebatterywillbesignificantly
reducedifyourdeviceisleftunchargedforalongperiod.
Wethereforerecommendthatyourechargeyourdeviceat
leastonceamonth.
TURNiNg yoUR hEAdSET oN ANd off
• Press the answer/end button until you see a burst of flashes on
the indicator light (leD) to turn your headset on.
• Pressandholdthe answer/end button until you see a burst of
flashes on the indicator light (leD) to turn the headset off.
please note that the leD indicator light turns off after 1 minute to
save battery. headset is still active, and light will flash again after
tap on the answer/end button or any call activity. To check if the
headset is on, tap the answer/end button once – the leD indicator
light will flash, if the headset is on.
PAiRiNg iT WiTh yoUR PhoNE
headsets are connected to phones using a procedure called ‘pair-
ing’. By following a few simple steps, a phone can be paired with a
headset in a matter of minutes. (See fig. 3)
1.Puttheheadsetinpairingmode
• When you turn on your Jabra BT2010 for the first time, the
headset will automatically start up on pairing mode – i.e. it is
discoverable for your phone. When the headset is in pairing
mode the leD is constantly lit.
2.SetyourBluetoothphoneto‘discover’theJabraBT2010
• Follow your phone’s instruction guide. First make sure that
Bluetooth is activated on your mobile phone. Then set your
phone to discover the headset. This usually involves going to a
‘setup,’ ‘connect’ or ‘Bluetooth’ menu on your phone and select-
ing the option to ‘discover’ or ‘add’ a Bluetooth device.*