Jabra GN9350e Setup Manual - page 2
Set-Up Guide
GN9350e
Jabra
®
is a registered trademark of gN Netcom a/s
www.Jabra.com
To receive a call with Office Communicator
• You will see a call notification on your computer
screen when you receive a telephone call. Click the
USB button on the GN9350’s base to answer the call.
If USB mode is set to default on the base, you can click
the headset’s answer button to answer the call.
To make a call with Office Communicator
One click calls:
• Make sure the GN9350’s base is in USB mode. (Refer
to Important note on the left side of this page) Then:
• Make one-click phone calls to contacts in your contact
list by selecting their name and clicking the call
button. A call window will pop up.
• You can also choose to answer by clicking on the
phone hook with the mouse.
• Finally if you are disturbed in a meeting, you can
choose to click ‘Redirect’ or choose to reply with
an Instant Message (you cannot redirect calls to a
phone number yet).
TIP:
The GN9350’s microphone can be
muted by pressing in on the volume
rocker on the headset. A red LED will
be lit on the base while the
microphone is muted (
C
).
IMPORTANT:
The GN9350 can be used as a headset
for a deskphone as well as a USB headset for Office
Communicator. It is in desktop mode by default, as
indicated by a blue LED below the deskphone button
on the base (
A
).
• Pressing the Answer/Release button on the headset
will pick up the call in whichever mode is set to default.
• The connection to the headset is active when the blue
LED is flashing.
• To switch to USB mode temporarily, press the USB
button on the base (
B
).
• To set USB mode as the default mode, press and hold
the USB button on the base for 5 seconds until the
blue LED button below the USB button is lit.
PUSH TO ANSWER
VOLUME CONTROL
AND PRESS TO
MUTE