JABSCO 60020-0000 Installation Instructions
Model
60020-Series
REMOTE CONTROL
SEARCH LIGHT
FEATURES
●
Constructed of noncorrosive ma te ri als
●
Sealed beam halogen lamp
●
Remote control and 15' cable in clud ed
●
Long life gear drive
●
Low amp draw
●
Patented clutch mechanism prevents motor damage
when running against limit stops
APPLICATION
Ideal for boaters...locate buoys, moorings, chan nel
markers, etc. Ideal for RV'ers...pin point road signs,
campsites, or use as backup light.
SPECIFICATIONS
●
320° horizontal movement
●
75° vertical sweep
●
50 watt 3-1/2" x 6" bulb
●
White thermoplastic housing and base
INSTALLATION INSTRUCTIONS
LIGHT MOUNTING
Select a location for the light which will allow for clear
beam projection forward and as far aft as pos sible.
Searchlight base should be mounted on level, flat
surface. Using the light base mounting template
enclosed, drill three (3) mounting holes and a center
hole at the center of base for wiring cable. Feed cable
through hole and fasten light in place with three (3) #10 x 1"
screws provided, or applicable screws for your particular
application. Mount light so that the Jabsco name on the
base is facing to the rear.
NOTE: SECURE CABLE WITH NYLON CLIPS OR
EQUIVA LENT. PROTECT INSTALLATION AT POINTS
OF STRESS, AND LEAVE ADEQUATE SLACK WHERE
CABLE MUST BE FLEXIBLE.
Remote Control Unit
Model
Weights
Standard
Number
Voltage
Amps
Candlepower
lb (kg)
Carton
60020-0000
12 Vdc
3.6
100,000
6 (2.7)
4
60020-0024
24 Vdc
2
100,000
6 (2.7)
4
CONTROL INSTALLATION (60030-0000)
Select a location near the helm which will allow for
convenient operation of control.
1.
Cut two holes (see Panel Cutout Template enclosed)
for mount ing control.
2.
Route power leads (supplied by customer) from volt-
age source to control. Note: Wiring must be 16
gauge (mini mum).
3.
Connect positive (+) power lead to red (+) wire and
negative (-) power lead to black wire using butt
connectors.
4.
Connect wires (matching colors) from control panel
to end of light cable using butt connectors provided.
5.
Use bedding compound or sealant to waterproof
control mounting.
6.
Secure control with self-tapping screws provided.
Model 60020-Series 135 SL