Jack Lananne's Power Juicer power juicer Operating Manual - Jack Lalanne Power Juicer
Chute
Lid with built-in
Pulp Guard
Pusher
Receptacle
Lid with built-in
Pulp guard
Blade
7
JACK LALANNE POWER JUICER
ASSEMBLY
(CONT.)
STEP 4:
Place blade inside filter, centered
over screw peg. Using orange
crescent tool, place its pegs
into the holes in the blade
and turn clockwise
until tightened.
IMPORTANT: Do not
over tighten as the
screw peg will break.
Remove crescent tool
and set aside.
CAUTION: Do not
leave tool inside juicer.
STEP 5:
Place lid with built-in pulp guard attached
on top of receptacle, making certain it is
snugly aligned with the pulp guard facing
in the opposite direction of the juice spout.
Lock lid into place by lifting locking bar
up until it clicks into grooves located
on both sides of the lid. Make sure
locking bar is in the full upright,
locked position.
IMPORTANT: The unit will not start
until this bar is properly locked in place.
STEP 6:
Insert pusher into chute.
Always use pusher to feed fruits
and vegetables into unit. Push gently,
never force. The blade will do the work.
4
5
6
Filter
Pulp
Collector
Crescent
Tool
Blade
Holes