Jack OA8000 Installation Instructions - page 2
Option 1: SENSAR
®
REPLACEMENT
1. Turn off antenna power injector at wall switch or A/V switch and raise the existing antenna.
2. Attach the RV antenna bracket to the JACK antenna with the 4 supplied sets of lock washers and screws.
3. Unscrew coax cable and remove existing Sensar
®
antenna (if present) from the retractable arm (keep retaining pins and clips).
Line up holes in RV antenna bracket with holes in retractable arm and re-insert pins thru assembly. Re-install retaining clips
(use new supplied retaining clips if necessary).
4. Fill end of existing coax cable with supplied dielectric grease and screw to antenna (DO NOT OVER TIGHTEN).
Note: If existing coax connector is corroded or damaged, replace with supplied new connector.
If installing new coax cable (sold separately), connect as stated, and then route properly thru retractable arm and into vehicle.
Make appropriate connections in vehicle.
Page 2
Option 2: POLE MOUNT BRACKET
1. Attach the L-shaped bracket to the JACK antenna with the 4 supplied sets of lock washers and screws.
2. Remove 2 existing screws and 2 existing washers from L-shaped bracket. Attach pole clamp to the L-shaped bracket with the
same screws and washers.
3. Place the clamp around an appropriate pole and tighten wing nuts.
4. Fill end of coax cable (sold separately) with supplied dielectric grease and screw to antenna (DO NOT OVER TIGHTEN).
Note: If replacing an existing antenna and the existing coax connector is corroded or damaged, replace with supplied
new connector. Route coax cable and make appropriate connections.
5. Position antenna for maximum signal reception and tighten wing nuts to secure the antenna in this position.
Antenna may be mounted in either
direction in order to clear obstacles such
as AC units or roof vents.
POLE MUST BE STATIONARY -
NOT ON A VEHICLE.
This is a directional antenna and
should be rotated on the pole to
the position that provides
maximum signal reception.