Jack OA8200 User Manual
Page 1
JACK
®
Digital HDTV Over-the-Air Antenna
w/built-in SureLock
®
Digital TV Signal Meter
OA8200 - White • OA8201 - Black
SPECIFICATIONS
Dimensions:
11.25” H x 16” W x 12.5” L
Weight:
2.3 lbs.
Frequency Bands:
VHF (47-230 Mhz) - 20 db gain
UHF (470-860 Mhz) - 25 db gain
Signal Meter
Frequency Response:
40-862 Mhz (Ch 2-69)
Powered Amplifier:
+12 Volt / 100 mA working
Power Supply:
Wall Mt. Switch (included)
• Mfr. # PB1000 - power supply, white
Enclosure/Mount:
ASA-Automotive grade
OPERATION
The Wall Mount Power Injector is a convenient way to
switch between your cable feed and over-the-air signals
from your JACK antenna.
To use the Power Injector, simply turn the unit on with the
ON/OFF button. When on (button depressed), the power
light will turn green indicating +12 volts to the antenna,
and the over-the-air signal from your JACK antenna will
be fed to the two TV outputs.
When off, the cable TV signal will be fed to the two TV
outputs if wired for cable TV input.
POSITIONING THE ANTENNA
1. Turn on antenna power at Power Injector Wall Mount Plate.
2. Turn on SureLock Signal Meter with switch on side of rotational knob enclosure.
3. Rotate attenuator dial fully clockwise.
4. Depress button on rotational knob and rotate antenna
until maximum number of LED lights illuminate on signal meter.
5. Rotate attenuator dial counter clockwise until last illuminated LED light flickers.
6. Rotate antenna to illuminate last flickering LED light.
7. Repeat steps 5 and 6 to pinpoint signal reception.
8. Follow instructions for TV or converter box to scan for available channels.
NOTE: In step 4, LED lights will illuminate from left (next to power) to right.
All LED lights may not illuminate depending on signal strength.
NOTE: Arrow on knob indicates which
direction antenna is pointing.