Jackco Sound 2 ZT51000 User Manual - page 2
5
D. Set-up
Turning the Speakers On and Off:
1. Power on: press and hold (Power Button) of both speakers at the same time for 4 seconds,
Bluetooth Indicator will start blinking and accompanied by power on ring tone.
2. Power off: press and hold
(Power Button) of one speaker for 4
seconds, Bluetooth indicator will stop
blinking and accompanied with power off
ring tone.
6
Pairing with Bluetooth Equipped Device:
1. Pairing the 2 speakers: Press and hold (Power Button) of both speakers until power is on,
it will enter pairing mode for 10~30 seconds, and accompanied by the Bluetooth indicator
fast blinking. Once it is paired, Bluetooth indicator will blink slowly and accompanied by a ring
tone (Pairing time will vary depending on external interference)
2. Press the (Bluetooth Pairing) once, it will enter into paring mode with cell phone or
Bluetooth device. When the speakers have paired with your device successfully, you be
prompted with a ring tone. On one speaker Bluetooth indicator becomes solid on (Master: Left
Channel), while the other speaker will blink on-off once every 3 seconds (Slave: Right Channel).
Note: You may see two devices on your Apple iPhone, iPad, or iPod. You can pick either one of the devices to pair.
-Press and hold (Bluetooth Pairing) can cancel pairing with cell phone.
-If your device prompts you for a passcode, please enter 0000.
2
7
Taking Calls with your connected to your phone:
When your phone receives an incoming call, a ring tone alert will come from your speaker.
To accept a call:
-Press the (Power Button) on the master speaker.
To end a call:
-Press the (Power Button) on the master speaker.
To reject a call or use call waiting feature, please revert to your phone controls.
2
2
8
F. Recharging Battery:
E. Connecting to via 3.5mm AUX input:
You can use speakers for music play with any device that has 3.5mm Audio out port.
Simply plug in the 3.5mm cable (included) into the speaker and into your device then play
music.
Connect the provided USB cable to the charging port on the
speakers and a USB charging block. Battery Indicator glows red
when battery is charging, and indicator changes to green when
battery is full.
The charging time is approximately 3 hours from an empty battery
2
2
AUX
USB
9
G. Factory Reset Pairing Procedure:
1.
2.
3.
4.
Power On
Pairing Speakers
4 sec.
30~60 sec.
A
B
Complete Pairing
Pair with Device
Press and hold for
4 seconds to power on
the speakers
A.) Press again on
both speakers. Bluetooth
Indicator will be fast
blinking accompanied by a
ringtone.
B.) Allow 30~60 seconds
for the speakers to pair
with each other. Once it is
paired Bluetooth indicator
will blink slowly and
accompanied by a ringtone.
Press the button on one
of the speakers to pair with
your bluetooth device.
Turn on Bluetooth and
search for “Sound²” and
click “Pair”. Play music to
confirm that the pairing
process is complete. If
not, repeat the process.
Bluetooth
<
Bluetooth
DEVICES
Now Discoverable
Sound²
Not Paired
Note: Please turn off the Bluetooth
connectivity on your device.
10
H. Troubleshooting
No audio from the speakers
A beep is heard during music play
Music playing through the speaker is
intermittent
Check if the Bluetooth device and
speakers are powered on and paired. Increase
volume from your Bluetooth device.
Battery is low, turn off speakers and recharge
the battery.
Make sure the distance between the
Bluetooth device and the speaker is
within the 30 foot range, or check if there
are any device/equipment that generates
electromagnetic interference.
Problem
Solution
2
2
2
Complete Pairing