Jackson 24P-NSU Service Manual - Installation Instructions

INSTALLATION INSTRUCTIONS 

DECK MOUNTING OF DISHMACHINE 

The dishmachine must be secured in place using the deck mounting tracks and caps 

provided with machine. 

STEPS :          

REFER TO FIGURE 1 

1.  Install the (4) adjustable feet provided into screw holes where shipping 

bolts were removed earlier. 

2.  Adjust the level of the dishmachine by screwing the adjustable feet in or 

out.  The front of the machine should be adjusted 1/4" to 1/2" higher 

than the back 

3.  Install  the  deck mounting hardware  as  shown  in FIGURE 1 to the deck at 

location where dishmachine will be permanently positioned.  Install 3/8  

inch stainless steel lug bolts to secure tracks and caps to deck. 

4.  Drill holes into deck as shown in FIGURE 1 and 

insure rear holes are located 2-1/4 inch from wall. 

5.  The tracks and the rear end caps maybe tightened at this time. 

6.  Slide dishmachine onto tracks and into position at rear end caps. 

7.  Install front end caps into place and adjust if necessary to remove any 

movement of machine,  if possible, tack weld tracks to deck. 

GRAVITY DRAIN SYSTEM

The drain from the dishmachine is a gravity drain system and should have the proper 

drop from the machine to floor drain system. 

STEPS :           REFER TO FIGURE 2

1.  Install hose to drain tube located at left rear of machine as shown in 

FIGURE 2. Drain tube is 1-1/2 inches in diameter and 7 inches from floor. 

[ PAGE 3 ]