Jackson Delta 1200 Technical Manual - page 26

Delta 1200 Technical Manual 07610-003-62-15 C

Issued: 10-27-2008 Revised: N/A

SECTION 5: SERVICE PROCEDURES

WASH TANK HEATER REPLACEMENT (CONTINUED)

21

5. Using the 3/8” nutdriver, remove the nuts securing the

heater wires to the heater. Then carefully pull the wires out of

the way.

6. Next, use the ratchet and 1/2” socket to remove the heater

mounting nuts.

7. Removing the heater may require that you reach into the

wash tank, grasp it and give it a push out of the wash tank.

8. Once the heater is pushed away from the tank wall, pull it

out with your hands.

9. Remove the old heater gasket and throw away.

10. Apply the new heater gasket.

11. Take the new heater and slide it through the hole in the

wash tank and line it up so the wash tank studs fit in the holes

on the heater flange.

12. Place the mounting nuts and lockwashers on the studs and

secure them with the ratchet and 1/2” socket.

13. Place the heater wires on the heater and tighten them

down using the 3/8” nutdriver.

Removing upper (wash) strainer.

Reaching into the wash tank.

Pulling the heater out.

Removing the heater nuts.

Using the ratchet to remove the heater mounting nuts.