Jackson Grills GSBSEAR-LP Owner's Manual - page 6
6
TECH TIP
A Certified Gas Fitter
should be used to install
fuel lines and other fuel
related components.
INSTALLATION INTO BUILT-IN CABINET:
STEP 1
Cut hole in cabinet to size as shown in Figure 7 (J,K,L; High-lighted in Yellow).
STEP 2
Install inlet fuel line and connect to Searing
Side Burner at the 3/8” flared
connection. (Sealant not required at this connection).
PROPANE: if the fuel line is installed independently of the BBQ Grill, a fuel regulator MUST be connected so that
inlet pressure is set at 11” Water Column.
NATURAL GAS: please ensure that inlet pressure does not exceed 4
” Water Column.
!WARNING!
SHUT OFF FUEL before
attempting to install this
side burner assembly.
Rev Feb 2012
N
M
O
Q
S
R
K
L
J
G
F
H
I
J =
9”
Width (Left to Right)
K =
17” Length (Front to Back)
L =
4 ½” Depth (Top to Bottom)
Figure 7
Non-Combustible material
ONLY