1. DL manuals
  2. Jackson Grills
  3. Grill
  4. JG3
  5. Owner's Manual

Jackson Grills JG3 Owner's Manual

Manual is about: Jackson OUTDOOR GAS BARBEQUE OWNER'S MANUAL JG3, JG4

Summary of JG3

  • Page 1

    O utdoor g as b arbeque o wner ’ s m anual this manual is for use with jackson grills 3 & 4 burner models m m o o d d e e l l s s j j g g 3 3 a a n n d d j j g g 4 4 warning: please read and understand the contents of this manual fully before operating. Failure to do so may result in fire or explosi...

  • Page 2

    2 a special message to our customers thank you for choosing the jackson grill for your new gas grill. This appliance is designed with quality components and we are confident that it will provide you with years of excellent operation. Please take the time to read the whole manual and familiarize your...

  • Page 3

    Safety your new jackson grill barbeque is a safe, convenient appliance when used and maintained properly. As with all gas-fired appliances, certain safety precautions must be observed. Failure to follow these precautions may result in damage or injury. If you have any questions or concerns regarding...

  • Page 4

    4 c learances 1. The appliance must have a minimum horizontal clearance from sides and back of unit to adjacent vertical combustible construction below and extending above the top of the unit 36 inches from sides and 36 inches from back of unit. 2. Do not locate this appliance under any overhead unp...

  • Page 5

    5 or the us department of transport (dot) for use in the usa. 2. The lp gas cylinder used for this appliance must not have a capacity larger than 20 lb. (9 kg): approximately 18” (46cm) high & 12” (30cm) diameter. 3. All lp gas cylinders used with this appliance should be inspected at every filling ...

  • Page 6

    6 o peration 1. Never connect your gas grill to an lp cylinder without the regulator provided, and never to an unregulated gas supply. The gas regulator supplied with the appliance must be used. 2. Always leak test the lp gas cylinder to regulator connection when connecting the lp gas cylinder to th...

  • Page 7

    7 gas only. The hose and hose couplings comply with cga standard can 1.83. No modifications or substitutions should be attempted. 4. Protect the hose from dripping grease and do not allow the hose to touch any hot surface, including the base of the grill. 5. Inspect the seal in the qcc cylinder valv...

  • Page 8

    8 leak test 1. Do not use or permit sources of ignition in the area while doing the leak test. This includes smoking. 2. Leak testing should be done once per year or whenever the lp gas cylinder or any other gas system part is replaced, whichever is more frequent. 3. The leak testing solution should...

  • Page 9

    9 this will allow the orifices to disengage from the burner venturi. 6. Unscrew each gas valve and re-install new natural gas valves and orifices. Use teflon tape or pipe dope when installing valves and orifices. G as l ine remove the 3/8” flare fitting that attaches the propane hose from the fittin...

  • Page 10

    10 charred remains with a wire brush or scraper. When used for the first time, the grill will emit a slight odor. This is a normal and temporary condition caused by the burn-in of internal paints and lubricants used in the manufacturing process and should not occur again. Simply run the main burners...

  • Page 11

    11 lighting instructions o pen l id ┌ ensuring all burner controls are in the off position, slowly turn on the gas supply valve. ┐ m ain b urner l ighting r ear b urner l ighting turn any main burner control to high position. Remove warming rack. Depress igniter button and hold or light with a match...

  • Page 12

    12 trouble shooting p roblem p ossible c auses s olution low heat or low flame when valve turned to high. For propane – improper lighting procedure. Ensure lighting procedure is followed carefully. All gas grill valves must be in the off position when the tank valve is turned on. Turn tank on for al...