1 models: jgsb-lp (propane) jgsb-ng (natural gas) version: oct 2015 owner’s manual: single side burner important notice please read all safety notices on pp. 2 before assembling or operating this side burner..
2 !Danger! If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If the odor continues, keep away from appliance and immediately call your gas supplier or your fire department. !Warning! 1. Do not store or use gasoline or other flammable liquids or vapors ...
3 certification & testing this side burner has been tested by labtest certification (lc) and has been tested to ansi z21.58b-2012 & csa 1.6b-2012, and certified for canada and the usa. Note: the use and installation of this product must conform to local codes. In the absence of local codes, use the ...
4 lid with handle: jh-000 cook grid: jg-19 burner: jb-22 burner support plate: jb-23 control knob: jk-14 chrome bezel: jk-17 main body (call dealer) orifice sizes: exploded diagram & parts list: propane: jf-141 #64 (11” w.C.) natural gas: jf-142 #53 (4 ” w.C.) cart model installation: tools required...
5 bend formed rails down slightly (if necessary) figure 1 figure 5 figure 6 figure 4 figure 3 figure 2: bottom view step 1 remove the cutting board from the right hand side shelf (the side burner can be installed only on the right hand side of the unit, as it will interfere with the rotisserie other...
6 tech tip a certified gas fitter should be used to install fuel lines and other fuel related components. Installation into built-in cabinet: step 1 cut hole in cabinet to size as shown in figure 7 (j,k,l; high-lighted in yellow). Step 2 install inlet fuel line and connect to side burner at the 3/8”...
7 figure 8 clearance to combustibles: a) top: from top of grate to any combustibles* above unit: 5 feet minimum *such as decks, ceilings, hanging plants, etc. B) rear: from rear of unit to any combustibles behind unit: 1 inch minimum c) side: from the outside edges the unit, to any adjacent combusti...
8 figure 9 figure 10 gas conversion: (optional orifice not included) 1. Remove the cook grid, heat shield, and burner, 2. Remove the original o rifice, using a ¼” socket wrench, with an extension and 7mm socket (fig. 9) 3. Lightly coat threads of the replacement orifice with teflon tape or gas fitti...
9 limited warranty: models: jgsb-lp & jgsb-ng side burner jackson grills warrants the materials and workmanship in this accessory to be free of defects for two (2) years from the date of purchase, to the original purchaser only. Two (2) year limited warranty subject to the following conditions & lim...
