1. DL manuals
  2. Jackson Grills
  3. Grill
  4. JGSBSEAR
  5. Owner's Manual

Jackson Grills JGSBSEAR Owner's Manual

Manual is about: Searing Burner Station

Summary of JGSBSEAR

  • Page 1

    1 version: mar13 owner’s manual: model # jgsbsear searing burner station jackson grills inc. #106-2480 mt. Lehman rd. Abbotsford, bc v4x 2n3 tel: 1(888) 287-3333 fax: 1(877) 855-5373 support: support@jacksongrills.Com web site: www.Jacksongrills.Com for outdoor use only !Warning! If you smell gas: 1...

  • Page 2: Table of Contents

    2 table of contents certification & testing: 2 safety warnings: 3 package contents checklist: 3 searing side burner part number list: 4 installation instructions: (cart version) 4-5 installation instructions: (built in version) 6-7 leak testing: 7 lighting instructions: 7 natural gas conversion: 8 w...

  • Page 3: !safety Warnings!

    3 !Safety warnings! Safety first: please read and understand all warnings and precautions prior to operating your side burner. 1 this accessory is for outside use only, and shall not be used in any building, garage, enclosed area or vehicle. 2 this side burner is set up from the factory for use with...

  • Page 4: Cart Model Installation:

    4 side burner part number list: cart model installation: tools required: 1 x 17mm wrench 1 x 19mm wrench step 1 remove the cutting board from the right hand side shelf (the side burner can be installed only on the right hand side of the unit, as it will interfere with the rotisserie otherwise.) !War...

  • Page 5

    5 bend formed rails down slightly (if necessary) figure 1 figure 2 figure 4 figure 3a figure 3b step 2 drop the searing side burner assembly onto the rails that formerly supported the cutting board. This may be a tight fit; if so, please bend the rails down slightly using a pair of pliers as needed ...

  • Page 6

    6 figure 6: built in cut-out dimensions** installation into built-in cabinet: step 1 cut/fabricate a hole in the cabinet to size as shown in figure 6; ‘cut out dimensions’ (high lighted in yellow). These dimensions are the actual cut out dimensions for the built in units in non-combustible applicati...

  • Page 7: Leak Testing:

    7 figure 6 step 2 install the main flex fuel line onto the 3/8” flared connection on the searing side burner manifold (fig. 2 above). (sealant not required). Propane grills: the inlet fuel line from the propane tank must not exceed 11” water column. If in doubt, please contact a professional gas fit...

  • Page 8: Natural Gas Conversion

    8 figure 7 figure 8 natural gas conversion 1. Remove the cook grid and cook grid support, then turn the searing side burner upside down. 2. Using a 10mm and 12mm wrench, remove the propane orifice (fig. 7). 3. Lightly coat threads of the natural gas orifice with gas teflon tape or gas fitting pipe d...

  • Page 9: Limited Warranty:

    9 limited warranty: model: jgsbsear searing side burner jackson grills inc. Warrants the materials and workmanship in this accessory to be free of defects for two years from the date of purchase. Limited warranty subject to the following conditions & limitations: (note: shipping and labor charges ar...