Assembly, use and care manual model no: jenc-lp model name: jackson grills encore for outdoor use only danger if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or yo...
2 messages to our users -----------------2 installer final check list-------------------14 important ----------------------------------- 4 grill lighting instructions-------------------14 installation safety precautions---------5 operation instructions-----------------------16 exploded view & parts ...
A special message to our customers: thank you for choosing the jackson grill for your new gas grill. This appliance is designed with quality components and we are confident that it will provide you with years of excellent operation. Please take the time to read the whole manual and familiarize yours...
4 the symbols and boxes shown below explain what each symbol means. Read and follow every message found in this manual. !!! Danger !!! Danger: indicates an imminently hazardous situation which will result in death or serious bodily injury if not followed. !!! Warning !!! Warning: warning of the poss...
5 !!!Warning!!! Do not try to install this applianc e without reading the “installation safety precautions ” section of this manual. 1. This grill is designed to use l.P. Gas only. Only use this grill with l.P. Gas and the regulator assembly supplied by the manufacturer. This grill is supplied with ...
6 exploded view & parts list.
7 ** part number format for ordering replacement parts is as follows: jenc-ref# example: jenc-02 : thermometer ref# description q ’ty ref# description q ’ty 01 hood 1 23 control panel 1 02 thermometer 1 24 rear burner ignition module 1 03 red insulator 2 25 pedestal side 2 04 hood handle 1 26 pedest...
8 please ensure the proper tools are used for ease of installation. Please remove all components from the packaging and inspect all components to ensure there is no damage to any components in the packaging. Please remove all packaging from all components of the gas grill before operating. tool re...
9 removed from these parts. These flame diffusers should be placed on the pins provided on the firebox front and rear. Ensure that all of the flame diffusers have been installed correctly on the pins provided or the unit will not work correctly. 2. Once the flame diffusers have been installed, the c...
10 1. Make sure tank valve is in its full off position (turn clockwise to stop). 2. Check tank valve to assure it has proper external male threads (type i connection per ansiz21.81). 3. Make sure all burner knobs are in their off position. 4. Remove the protective cap from l.P. Tank valve, always us...
11 very important: disconnect the tank when this grill is not in use. to disconnect l.P. Gas tank: 1. Turn all the knobs off. 2. Turn the tank valve off fully (turn clockwise to stop). 3. Detach the regulator assembly from tank valve by turning the quick coupling nut counterclockwise. 4. Install t...
12 work area. This will ensure you do not re-install the propane orifices. 5. Using an approved thread sealant, replace the main burner orifices with the new natural gas orifices supplied. 6. Before reinstalling the main burners make sure to close the air shutter on each burner half of what it is se...
13 general although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation site due to possible mishandling in shipment, or excessive pressure unknowingly being applied to the unit. Periodically check ...
14 at least 36 ” clearance maintained from combustible constructions to the sides and back of this grill. there is no unprotected combustible construction over the grill. all internal packaging removed. burners are sitting properly on orifices. knobs turn freely. the regulator & hose con...
15 the grill as possible when lighting 3. Open lid during lighting. 4. P ush and turn rear burner control knob to the “high” position. Push and hold igniter button until burner lights. Up to 5 seconds is allowed for ignition. 5. Follow match lighting instruction if burner can ’t be lit after repeati...
16 !!!caution!!! 1. Clean your grill often. Failing to do so may cause a grease fire that may damage the grill. Please clean your grill frequently. 2. Never leave the grill unattended while using. 3. Do not use water to extinguish a grease fire, it may cause body injury. Turn knobs off and l.P. Tank...
17 using the grill: grilling requires high heat for searing and proper browning. Most foods are cooked at the “hi” heat setting for the entire cooking time. However, when grilling large pieces of meat or poultry, it may be necessary to turn the heat to a lower setting after the initial browning. T...
18 maintenance 1. Keep the grill area clear and free from combustible materials, gasoline and other flammable vapors and liquids. 2. Keep the holes in the three sides of the cart clear and free from debris, thus ensure the flow of combustion and ventilation air is unobstructed. 3. Visually check b...
19 spider and insect warning spiders and insects can nest in the burners after storing, these nest can cause fires inside the tube or beneath the grill. This is very dangerous condition. So always clean the burners before use after storing. when to look for spiders inspect the burners at least o...
20 the flow limiting device or bypass safety feature what is the flow limiting device/ bypass safety feature? Lp tanks are required to add a flow limiting device (fld) to all 20 lb tanks. This device prohibits gas flow when an excessive amount is detected why does this occur? Generally the fld is tr...
21 model no.: jenc-lp (encore) jackson grills inc. Warrants the following materials and workmanship to be free of defects for as long as you own the grill. This covers the following components: main stainless steel outer hood, stainless steel handle, stainless steel burners, inner hood, firebox, fla...