Jacob Jensen IP20 User Manual - page 6
6
C.2 SIP Settings
SIP Proxy: Setting SIP service
address.
SIP User ID: Setting SIP User ID.
SIP Authentication ID: Setting SIP
authentication ID.
SIP Authentication PIN: Setting SIP
authentication PIN.
User Name: Setting SIP user name.
NOTE: The default option of SIP
Registration is Yes. Please make
sure that this option is Yes, when
you are switching the mode by
the handset.
Subscribe for MWI: Configure
phone voice mail indicator, if
voice mail function is available,
phone MSG indicator would shine.
Message Service Number:
Configure voice mail number.
Use Hotline: Configure hotline
function.
Hotline Number: Configure
hotline number.
C.3 Call Setting
Preferred Voice Codec: Configure
voice codec model.
Use # to dial immediately:
Configure fast dial function
enable or not.
The time wait to dial out:
Configure the time for sending
the dialled number.
The pause time (1-5s): Set pause
time.
NOTE: Please click OK after finished all the above setting. The phone would
automatically save the setting and reset. Then you can make a call using the
account you just registered.
C.4 Upgrade files
Upgrade Firmware: Click “Browse”
and choose the software, which
need to be upgraded. Click “Start
Upgrade” to initiate the upgrade.
The phone will go back to the
original log in status.
IMIP20_04052016.indd 6
04/05/16 10:16