Jacto HP726 Owner's/operator's Manual - Specifications
4
Specifications
HP726 Dry Weight ............................................................................. 9.2 kg/20.2 lbs.
Engine Model ..................................................................................... Shindaiwa S230
Engine Type ...................................................... 2-cycle, vertical-cylinder, air-cooled
Bore x Stroke ................................................................... 32 x 28 mm/1.26 x 1.10 in.
Displacement ................................................................................. 22.5 cc/1.4 cu. in.
Maximum Power Output .............................................. 0.8 kW/1.1 HP @ 7500 rpm
Fuel/Oil Ratio ............................ 50:1 with Shindaiwa Premium 2-cycle Engine Oil
Fuel Tank Capacity ............................................................................ 600 ml/20.3 oz.
Carburetor Type ...................................................... TK slide valve, diaphragm-type
Transmission Type ............. Automatic,centrifugal clutch through gear reduction
Ignition .......................................................... Fully electronic, transistor-controlled
Spark Plug .............................................................................................. NGK BMR6A
Air Cleaner Type ............................................. Foam element,quick-remove/install
Starting Method ................................................................................................. Recoil
Stopping Method .................................................................................. Toggle switch
Spayer Pump Type .......................................................... Horizontal duplex plunger
Three Stage Pump Pressure Range .............. 10, 20, 25 kgf/cm
2
/142, 284, 357 psi
Maximum Pump Pressure ........................................................ 25 kgf/cm
2
/357 psi
Chemical Tank Capacity ............................................................... 26 liters/7 gallons
DESCRIPTION
Prior to Assembly
The HP726 engine sprayer is shipped
in one carton. Before assembling your
HP726, make sure you have all the
components required for a complete
unit:
!
Engine, pump and chemical tank
assembly
!
Sprayer hose
!
Trigger valve
!
Spray wand
!
Two head spray nozzle assembly
Super 25 and (D-3) nozzles (2 ea.)
!
This manual and tool kit for routine
maintenance.
Carefully inspect all components for
damage.
IMPORTANT!
The terms “left”, “left-hand”, and “LH”;
“right”, “right-hand”, and “RH”; “front”
and “rear” refer to directions as
viewed by the operator during normal
operation.
*Specifications are subject to change without notice.