2003+ protech tm led series owner’s manual.
Attention new spa owner! Congratulations on the purchase of your new jacuzzi premium spa! Listed below are important maintenance recommendations you should observe on a regular basis to protect your new investment. Filter maintenance your new spa is equipped with an advanced 2-stage water filtration...
Table of contents 1.0 important spa owner information ..........................................1 2.0 fcc notice......................................................................................1 3.0 important safety instructions ...................................................2 3.1 important...
10.0 automatic filtration cycles .....................................................28 10.1 standard skimming/heating modes (f0 - f3) ...............................28 10.2 economy skimming/heating modes (f4 - f6)...............................28 10.3 lock modes (l1 - l2).............................
1.0 important spa owner information your jacuzzi® premium spa is constructed to the highest standards and is capable of providing many years of trouble-free use. However, because heat retentive materials are utilized to insulate the spa for efficient operation, an uncovered spa surface directly expo...
3.0 important safety instructions when installing and using this electrical equipment, basic safety pre- cautions should always be followed, including: 1. Read and follow all instructions before operating the spa! 2. Warning: to reduce the risk of injury, do not permit children to use this product u...
B. Since excessive water temperatures have a high potential for causing fetal damage during the early months of pregnancy, pregnant or possibly preg- nant women should limit spa water temperatures to 100 °f (38 °c). If pregnant, please consult your physician before using a spa. C. Before entering th...
C. Warning: people with infectious diseases should not use a spa. D. Warning: to avoid injury, exercise care when entering or exiting the spa. E. Warning: do not use drugs or alcohol before or during the use of a spa to avoid unconsciousness and possible drowning. F. Warning: pregnant or possibly pr...
2. The consumer products safety commission has stated that the water temperature in a spa should not exceed 104 °f (40 °c). Immersion in water in excess of 104 °f (40 °c) can be hazardous to your health. 3. Observe a reasonable time limit when using the spa. Long exposures at higher temperatures can...
120/240 volt convertible models a spa connected to a 120 vac electrical service must be located close enough to a grounded, grounding-type electrical outlet so that the included power cord can be plugged directly into it. Do not use an extension cord as this could cause damage to the spa’s equipment...
3. The closeness to trees and shrubbery (remember that leaves and birds could create extra work in keeping the spa clean). 4. A sheltered environment (less wind and weather exposure can result in lowered operation and maintenance costs). 5. The overall enhancement of your environment. It is preferab...
Us / canada j-310 1-pump convertible model (60hz) 120v/15a* 240v/30a* 240v/40a** voltage: 120 vac 240 vac 240 vac # of wires: 3 (15a gfci cord) 4 4 frequency: 60hz 60hz 60hz current draw: 12a 21a 30a circuit breaker: 15a, 1-pole 30a, 2-pole 40a, 2-pole for 240 vac heater operation: move the red wire...
Export j-310 / j-320 / j-330 1-pump models (50hz) 230v/20a* 230v/30a** voltage: 230 vac 230 vac # of wires: 3 3 frequency: 50hz 50hz current draw: 15a 21a circuit breaker: 20a 30a * in the 20a configuration, the heater will not operate at the same time as the main jets pump. This is the factory sett...
6.0 electrical wiring instructions important notice: the electrical wiring of this spa must meet the requirements of the national electrical code (nec) and any applicable state or local codes. The electrical circuit must be installed by a qualified electrician and approved by a local build- ing/elec...
Page 11 figure-b - control box 1. Terminal block 2. Bonding lug 3. Grounding terminal tb1 3 2 1 9 10 4 3 7 1 2 2 figure-a equipment area 1. Control box 2. Power supply entrance(s) 3. 2-speed pump #1 4. Heater 5. Spa drain valve 6. Pump drain plug(s) 7. 1-speed pump #2 8. Circulation pump 9. Optional...
7.0 start-up instructions congratulations! You are now all set to get your new spa ready to use. Simply follow this step-by-step procedure and, before long, you will be enjoying your first glorious experience in your jacuzzi premium spa. For best results, read each step in its entirety before procee...
If your water is extremely “hard”, it is preferable to fill half-way with hard water and the rest of the way with softened water. Or, you may fill entirely with hard water if you use a special water additive available from your jacuzzi premium dealer. Always refill spa half way through both filter w...
8.0 control functions 8.1 control panel a. Led display: can display current water temperature (default display), water temperature setpoint, selected skimming/heating mode, and error messages. B. Warmer ( + ) button: increases water temperature setpoint. C. Cooler ( - ) button: decreases water tempe...
Page 15 8.2 spa features and controls 1. Control panel 2. Air controls 3. Filter/skimmer grill 4. Maxx powerpro jets 5. Therapy jets 6. Diverter valve 7. Therapy seat 8. Spa light 9 vertical jets (foot jets) 10. Footwell suction fittings and filters. 11. Waterfall feature 12. Heater return fitting 1...
Page 16 j-310 massage selector operation rotate massage selector 1 to divert water between jet groups a-b. Massage selector #1 controls the main pump’s water flow. Massage selector #1 controls the main pump’s water flow. Air control operation depress air controls a or b to open or close air inlet to...
Page 17 massage selector #1 controls the main pump’s water flow. Massage selector #1 controls pump 1. Seat jets c and footwell jets d are powered by pump 2. Air control operation depress air controls a-c to open or close air inlet to designated jet groups. Air control operation depress air controls ...
Page 18 9.0 operating instructions the spa control system has automatic functions that operate upon start-up and normal operation to protect the system. Upon power up, the readout displays the following information: 1. Control panel displays current software release (e.G. 3.54), then; 2. Control pan...
That allows you to customize the massage and performance by diverting water between various jet systems. Simply turn massage selector to position a (combo), b, or c to divert water pressure to various jet groups. Note: the valve is designed to operate in positions a (combo), b, and c for optimum per...
Both speakers located on spa corners (sec. 8.2, page 15) are designed for manual extension and retraction. To expose each speaker for audio, simply press it’s release button to unlatch the “pop-up” mechanism. To retract each speaker before covering spa, gently press downward on each speaker enclosur...
C. Volume press blue vol or vol button to adjust volume to desired listening level. D. Adjust treble press blue sel button two times to select treble mode. Then press blue vol or vol button to adjust treble range from -7 to +7. E. Adjust bass press blue sel button three times to select bass mode. Th...
G. Adjust fader press blue sel button five times to select balance mode. Then press blue vol or vol button to adjust speaker balance as desired. Note: f15 = front speakers only; r15 = rear speakers only. H. Bass boost press grey loud button to increase the bass output. Loud appears on the display. I...
Optional stereo receiver - weather band and radio operation a. Select a weather band the stereo receiver has a three chan- nel noaa weather radio receiver. Noaa weather radio broadcasts national weather service warnings, watches, fore-casts, and other hazard information 24-hours a day. Press the gre...
C. Program a station preset six numbered green preset buttons (1-6) store and recall stations for each radio band. Save a station preset: 1. Press grey band button to select desired radio band, if necessary. 2. Select radio station by pressing blue + button or - button. 3. Press green preset button ...
F. Prescan stations scans stations stored in current band. 1. Press grey band button to select desired radio band, if necessary. 2. Press grey as/ps button for less than 3-seconds. The radio pauses for 5-seconds at each station. Press grey as/ps button again to stop scanning when desired station is ...
D. Repeat the same track press green rpt button to continuously repeat same track. Press again to stop repeat. E. Shuffle play all tracks press green shf button to play all tracks on cd in random order one time. Press again to stop shuffle play. F. Scan (preview) all tracks press green scn button to...
Optional stereo receiver specifications cd player signal/noise ratio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>86 db frequency response . . . . . . . . . . . . . . . . . . . . . . . .20 hz - 20 khz channel separation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .>65 ...
Page 28 10.0 automatic filtration cycles your new spa includes a 24-hour circulation pump which filters the water continuously while using less energy than a common 100 watt light bulb! The circulation pump draws water through the skimmer bag and one of two filter cartridges to effectively remove sm...
Buttons at the same time, then release. Then press either warmer ( + ) or cooler ( - ) button to select skimming/heater mode f0-f6 or lock modes l1-l2 below: standard skimming/heating modes f0 5 minutes of skimming per day (one 5 minute “blow-out” cycle every 24 hours to purge all plumbing lines) f1...
1 1.0 spa maintenance proper and regular maintenance of your spa will help it retain its beauty and performance. Your authorized jacuzzi premium dealer can supply you with all the information, supplies, and accessory products you will need to accomplish this. 11.1 cleaning the filters your jacuzzi p...
*note: to maximize filter life, switch filter cartridge positions at each cleaning. Periodically, both filter cartridges will need a more thorough cleaning to remove imbedded oils and minerals. For this, we suggest cleaning as illustrated above (step f), followed by soaking the filter overnight in a...
Water quality maintenance. Replacement cartridges may be purchased from your jacuzzi premium dealer. 11.2 draining and refilling about every 3 to 6 months, you will want to replace the spa’s water. The fre- quency depends on a number of variables including the amount of use, atten- tion paid to wate...
11.3 cleaning the spa interior to preserve the sheen of your spa's surface, it is crucial that you avoid using abrasive cleaners or cleaners which have adverse chemical effect on the surface. If you are not certain as to the suitability of a particular cleanser, consult your authorized jacuzzi premi...
11.6 maintaining the wood cabinet with time and exposure to the elements, the wood on your spa will tend to loose its new appearance. Protecting or reviving the wood surfaces is a fair- ly simple process. Light sanding with fine-grit sandpaper will help smooth any roughness and regular applications ...
3. When the water level ceases to drop, use whatever means available to remove any remaining water from the footwell. 4. Turn off power to the spa. 5. Remove the equipment-side cabinet panels and locate the drain plugs in the front of the pump(s) (figure-a, page 11). Remove these plugs to allow the ...
12.1 ph control ph is a measure of relative acidity or alkalinity of water and is measured on a scale of 0 to 14. The midpoint of 7 is said to be neutral, above which is alka- line and below which is acidic. In spa water, it is very important to maintain a slightly alkaline condition of 7.2 to 7.8. ...
An overheat condition. This setting is not user-programmable. Note: the summer logic does not take effect until the spa water tempera- ture reaches 95 °f (35 °c). This condition is more likely in excessively hot weather. Remember, the spa’s ability to cool is directly affected by the ambient tempera...
• this error will cause the heater to deactivate. The main pump #1 may also deactivate. • this problem is caused by an interruption in water flow from an excessively dirty filter cartridge, an “air lock” condition at the pump intake, or by a malfunctioning flow switch. To correct condition: 1. Check...
14.0 troubleshooting procedures in the event your jacuzzi® premium spa is not working the way it should, please first review all the installation and operating instructions in this manual and check the message on the panel display. If you are still not satisfied it is working properly, please follow...
Page 40 should checking the above steps fail to correct the problem, please call your dealer so that they may arrange service. We build the best spas in the industry. Nonetheless, we are always striving to improve the quality and features of our products. Your input as a jacuzzi premium spa owner is...
Page 41 15.0 j-310 convertible circuit diagram (60hz) this wiring diagram is used for the j-310 us/canada 120/240 vac (60hz) convertible power model. Ozonator o 3 grn tb1 standard 120 v ac 3-w ire connection (60 hz, 1 phase, 15 a service) use copper conductors onl y . Wire size must be appropriate p...
Page 42 optional stereo and power supply on j-340 models only . Power supply ozona t or (optional) o 3 grn tb1 standard 240 v ac, 3-w ire connection (60hz, 1-phase service) use copper conduct ors onl y . Wire size must be appropria te per nec and/or local codes red red j6 blk j5 wht wht wht wht red ...
Page 43 17.0 j-310 export circuit diagram (50hz) this wiring diagram is used for the j-310 export 240 vac (50hz) dedicated power model. Ozonator o 3 tb1 230 v ac, 3-w ire connection (50hz, 1-phase service) use copper conduct ors onl y . Wire size must be appropria te per nec and/or local codes 2 1 f...
Page 44 optional stereo and power supply on j-340 models only . Power supply ozona t or (optional) o 3 grn tb1 230 v ac 3-w ire connection (50hz, 1-phase service) use copper conduct o rs onl y . Wire size must be appropria te per nec and/or local codes blu blu j6 brn j5 brn wht brn blu blk blu blk b...
Notes:.
Jacuzzi ® premium 14525 monte vista ave. • chino, ca 91710 website: http://www.Jacuzzipremium.Com 6530-225, rev. D © 2002 jacuzzi premium printed in u.S.A..