E-1686 1/99 congratulations! You have purchased one of the most user- friendly pool filter systems available. Jacuzzi is a leader in providing superior products, combining easy installation and simple service. This filter system manufactured by jacuzzi bros. Will provide you with many years of pool ...
Introduction: inside: setting up your equipment...........................4-5 plumbing the system to your pool..................6 starting your system......................................7-8 filter regeneration.......................................9-11 cleaning the pump strainer......................
(a) (b) (c) what you should have: contents of carton: tools you will need: for most installations all you will need are (a) screw- driver (b) wide mouth pliers and (c) adjustable wrench. 3 pump base d.E. Filter 123 123 123 123 123 123 123 123 123 123 electrical data: refer to information on motor na...
Setting up your system: step 1 install threaded end of interconnect pipe into the filter “inlet.” tighten until o-ring seals against filter. Note: be sure union nut is placed on inter- connect pipe before it is threaded into filter. Threads on union nut should face away from the filter. Step 2 place...
Setting up your system: step 4 push the grommet nuts into the pre-drilled holes in the system base. Use the illustration at the right to ensure the correct holes are used. Position the pump on the base and connect the union nut on the interconnect pipe to the pump discharge and hand tighten only. In...
Typical above-ground pool connection: 6.
System startup: caution: water acts as a coolant for the seal. Do not operate your pump until it has been filled with water (primed). Important: this filter is a diatomaceous earth (d.E.) type filter and requires d.E. In order to operate. Do not operate filter without d.E. Step 1 open the air bleed ...
8 step 4 open air bleed valve to release any additional trapped air. When a steady stream of water appears, close the valve. Step 5 pour d.E. Mixture into pool skimmer slowly to allow d.E. To be pumped into the filter for coating. Allow 3-5 minutes for grids to coat sufficiently. Important: do not o...
9 note: regeneration of the d.E. Filter is done to extend the filter cycle before cleaning of the grid cassette becomes necessary. If a 10 p.S.I. Increase is indi- cated by the filter pressure gauge, follow the filter regeneration steps below. If filter ring-lok is removed or adjusted under pressure...
Filter regeneration: step 3 when full stroke is obtained, slowly move handle up and down 4 to 5 times, then return wiper blades to bottom position of stroke. Step 4 plug pump into 3 prong grounded electrical receptacle. Note pressure reading. If pressure gauge reading increases 10 p.S.I. Within 72 h...
Cleaning the pump strainer: to avail electrical shock, unplug the pump before performing any service or maintenance. If filter ring-lok is removed or adjusted under pressure, the filter cover may blow off, causing injury or major property damage. Unplug the pump cord. Step 1 for above-ground pools w...
Step 4 lift the basket out of the strainer and remove the debris. Reinstall the basket. Step 5 clean the o-ring on the clear strainer lid and re-lubricate with petroleum jelly. Also, clean all surfaces that come in contact with the o- ring to assure a good seal. Step 6 replace the clear cover and st...
Cleaning the d.E. Grid cassette: to avoid electrical shock, unplug the pump before performing any service or maintenance. If filter ring-lok is removed or adjusted under pressure, the filter cover may blow off, causing injury or major property damage. Unplug the pump cord. Step 1 for above-ground po...
Cleaning the d.E. Grid cassette: step 4 press down on yellow safety latch and rotate the large ring-lok nut counter-clockwise. Using both hands continue to unscrew the ring-lok nut. Remove and set aside. Step 5 remove the cover by pulling upward on the handles, rocking gently if necessary. Note: be ...
15 cleaning the d.E. Grid cassette:.
16 cleaning the d.E. Grid cassette:.
17 cleaning the d.E. Grid cassette:.
18 note: some models have a plastic buckle in place of the velcro. Once the straps are in place, pull upward on the buckle to tighten the straps. Ensure plastic spacer is inserted into collar on the support plate. Cleaning the d.E. Grid cassette:.
19 cleaning the d.E. Grid cassette: step 19 align wiper rod to fit through hole in top of the cover. Place the cover on the filter body and press firmly downward until the cover comes to a stop against the filter body. Tip: it is easier to replace the filter cover if the air bleed valve is open. Ste...
Winterizing the filter system: to avoid electrical shock, unplug the pump before performing any service or maintenance. If filter ring-lok is removed or adjusted under pressure, the filter cover may blow off, causing injury or major property damage. Step 3 drain the pump strainer and pump case by lo...
21.
. Reassemble of your equipment makes him the best qualified source 22.
12401 interstate 30 p.O. Box 8903 little rock, ar 72219-8903 telephone: 501/455-1234 jacuzzi limited warranty jacuzzi bros. Division (jbd) warrants its products to be free of defects in material and workmanship for a period of 1 year from date of purchase or 3 years from date of manufacture, whichev...
