Jacuzzi J-DREAM 90 Owner's Manual

Manual is about: Shower System Right Hand & Left Hand Models

Summary of J-DREAM 90

  • Page 1

    Owner’s manual installation & operating instructions j-dream 90 shower system right hand & left hand models tm whirlpool bath r.

  • Page 2: J-Dream 90

    J-dream 90 (left hand shown) dimensions in inches 1.

  • Page 3: Important Safety Information

    Important safety information read all installation instructions jacuzzi whirlpool bath does not recommend prolonged periods of use of the steamer. Prolonged use of the steam system can raise the internal human body temperature excessively and impair the body's ability to regulate its internal temper...

  • Page 4: Electrical Requirements

    Installation & operating instuctions (right hand & left hand models) electrical requirements your j-dream, as it comes from the factory, requires a gfci 240 vac15 amp 3-wire circuit (2 conductor with ground) for single (1) phase electrical service and must be in a separate circuit having no other ap...

  • Page 5

    Read all instructions before beginning installation. Room construction: important the room where the shower unit is to be located must be constructed of materials that can withstand excessive amounts of moisture and condensation. Large amounts of steam can be released into the room when the shower d...

  • Page 6: (Left Hand Model)

    Installation & operating instructions (left hand model) washing machine outlet box connect #8 gauge (10mm2) minimum solid copper bond wire to the house electrical panel or approved local ground. An approved ground may be an 8 foot long ground rod (3 meter long earth rod), a plate electrode, or other...

  • Page 7: (Right Hand Model)

    Installation & operating instructions (right hand model) washing machine outlet box connect #8 gauge (10mm2) minimum solid copper bond wire to the house electrical panel or approved local ground. An approved ground may be an 8 foot long ground rod (3 meter long earth rod), a plate electrode, or othe...

  • Page 8: Bonding

    Installation & operating instructions connect #8 gauge (10mm 2) minimum solid copper bond wire to the house electrical panel or approved local ground. An approved ground may be an 8 foot long ground rod (3 meter long earth rod), a plate electrode, or other acceptable bond location. Check your local ...

  • Page 9

    • connect hot and cold water supply hoses. • plug in electric line cord. • move j-90 into final position. • install drain, connect to stub-out using band seal coupling provided. • adjust the leveling screws in the base frame feet and lock them into position. • secure j-90 in position using clamps pr...

  • Page 10: Shower

    System control is provided by the electronic display located inside the shower cabin (see fig. 2) the display is used to start up the four functions of the unit: the shower, the cascade, the hydromassage and the steam bath. The display is composed of four distinct areas with clear symbols which allo...

  • Page 11: Starting The Hydromassage

    Starting the hydromassage the j-dream ii allows you to enjoy the benefits of a real hydromassage. The hydromassage is created by the combined action of 16 water jets (four sets of four) under the pressure of an electrically powered pump. The action of each group of four jets is alternated according ...

  • Page 12

    11 during the steam bath treatment, the time can always be varied by pressing the (+) and (-) buttons without interrupting the functions. Also for your convenience, a buzzer will sound when the steam timer reaches zero (00). There is a 10 second delay before the steam bath function is cancelled. Dur...

  • Page 13

    Electrical diagram double -pole cable 0,75 mm 2 h 0,5 (length = 3100 mm) with fast terminals (12v) sol. Valve, drainage sol. Valve, filling sol. Valve, filling sheathed cable to solenoid valves (length = 1000 mm) with fast terminal (12v). Sol. Valve, waterfall sol. Valve, shower sol. Valve, turbo 3 ...

  • Page 14

    © copyright 1994 jacuzzi whirlpool bath c970000 a 4/94 jacuzzi whirlpool bath national headquarters p.O. Drawer j, walnut creek, ca 94596 (510) 938-7070 customer service: call (800) 288-4002 printed in the u.S.A. Printed on recycled paper jacuzzi whirlpool bath has obtained applicable code (standard...