1. DL manuals
  2. Jade
  3. Griddle
  4. JGGM
  5. Installation, Operation And Maintenance Instructions

Jade JGGM Installation, Operation And Maintenance Instructions

Summary of JGGM

  • Page 1

    P/n 2411600000 rev. D 07/2011 page 1 jade range llc, a middleby company 2650 orbiter ave. Brea, ca 92821 telephone (714) 961-2400 fax (714) 961-2550 models: jgm, jggm, jgt, jgts, jgtsd, jgtsds, jggt, jggts, jtyg griddles and jhp, jhpe hot plates installation, operation and maintenance instructions n...

  • Page 2

    P/n 2411600000 rev. D 07/2011 page 2 installation instructions important read these instructions carefully before starting the installation. Upon receipt of your equipment, thoroughly inspect it for any damage. If any damage is noted, immediately file a claim with the trucking company. Failure to co...

  • Page 3

    P/n 2411600000 rev. D 07/2011 page 3 gas piping a regulator is provided with this appliance set a 5” w.C. For natural gas or 10” w.C. For propane gas. A conveniently located gas shutoff valve, external to the appliance, is required for complete shutdown. Be sure all valves are in a closed position b...

  • Page 4

    P/n 2411600000 rev. D 07/2011 page 4 for jgt and jggt griddles with (modulating thermostats) 1. Turn pilot valves and thermostat to “off.” wait 5 minutes. 2. Through the observation opening on the front panel, with a screwdriver, open the pilot valve with a screwdriver and immediately light the pilo...

  • Page 5

    P/n 2411600000 rev. D 07/2011 page 5 for model jgtsd, turn on the main valve at the rear and rapidly rotate igniter knob. A multiple clicking should be heard from the igniter indicating a spark is being provided to the pilot. When the pilots are lit, turn on the red valve handle in front and set the...

  • Page 6

    P/n 2411600000 rev. D 07/2011 page 6 checking the griddle plate temperatures use a surface probe such as the one pictured below to check the griddle temperatures. Locate the probe on the griddle plate just above each thermostat sensing bulb at the center of each burner. The temperatures should fluct...

  • Page 7

    P/n 2411600000 rev. D 07/2011 page 7 an accuracy of + /– 15°f is attainable with the jgts snap action thermostat. The jgtsd and jgtsds thermostats will have a maximum accuracy of + /– 19°f. Maintenance instructions contact the factory, factory representative or a local service company to perform mai...

  • Page 8

    P/n 2411600000 rev. D 07/2011 page 8 repair guidelines all repair work must be completed by a license-trained service person experienced in commercial gas foodservice equipment. If it becomes necessary to replace any gas control device, such as a main burner valve or thermostat, the replacement part...