Jade RJCT30 Installation Instructions Manual

Manual is about: Jade Sealed Gas Cooktop

Summary of RJCT30

  • Page 1

    Installation instructions jade sealed gas cooktop please read this manual completely and carefully before proceeding. Note to the installer: please leave this manual with the cooktop for the consumer. Note to the consumer: please retain this manual for future reference. Important the installation of...

  • Page 2: Unpacking and Inspection

    Important safety instructions warning: if the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. Do not use this appliance as a supplement to your furnace/heater. It is not designed to heat the kitchen or any other ro...

  • Page 3: Rjct Model Configuration

    3 safety rjct model configuration and specifications electrical characteristics: 120v, 1-phase, 60 cycles current draw for 12” griddle ......................................... 4 amps circuit breaker rating: 10 amp for all models model dim “a” rjct30 30 rjct36 36 rjct48 48 safety instructions rjct30...

  • Page 4: Clearances From

    4 installation clearances from combustible surfaces: the jade gas cooktop must be installed in accor- dance with the minimum clearances as illustrated. In order to reduce the hazards in reaching over the appliance, avoid placing cabinets directly above the cooktop. When installed, the maximum depth ...

  • Page 5: Installation Layout

    5 installation layout installation installation side view 3/4 1 24 9 1/2 9 1/2 9 1/2 angle support (supplied with appliance) 25 side of unit with 3-prong angled plug rear view 3 3 1/2 pipe 11 6 3/4 cord (veritical or horizontal regulator connection) 3/4 npt pipe convertible built-in a 120v/1-ph/60hz...

  • Page 6: Gas Connection

    6 operation gas connection this appliance can be used with natural gas or lp gas. It is shipped from the factory adjusted for use with the gas specified on the nameplate. (see page 4 of the user manual, for the location of the nameplate.) please note that this appliance is not field convertible. Shu...

  • Page 7: Electrical Connection

    7 electrical connection the jade gas cooktop requires a 120 volt, 60 hertz, single phase, individual and properly grounded branch circuit. The circuit must be protected with a 10 amp circuit breaker or time-delay fuse. This appliance is equipped with a three-prong (grounding) plug for your protectio...

  • Page 8

    8 rjct3080a rjct3680a rjct3683a rjct3681a rjct4881a rjct4883a.

  • Page 9: Operation

    Initial startup and adjustment the air for combustion and ventilation is supplied through the front of the cooktop. The air is exhausted upward. Do not obstruct the flow of combustion and ventilation air. Before startup, make sure that the cooktop has been carefully checked for gas leaks and that it...