Orchestra orchestra reference integrated amplifier owner's manual.
Table of contents introduction warning unpacking and checking description installation instruction tube position how to match your amplifier to your loudspeaker how to turn on your amplifier maintenance orchestra specifications.
Introduction at jadis , we are very proud to release a new product after a lengthy period of experimentation and trial. Our jadis amplifier is therefore the result of long months of technical research and countless hours of listening. Enjoy your amplifier. We thank you for your trust in our product..
Warning read this document thoroughly before any manipulation. Then read step by step when installing..
Unpacking and checking the orchestra integrated amplifier has been packed in a box that has been specially designed for it. Do not throw away this box as it will be needed for re-packing the unit when it has to be returned to the factory for maintenance or upgrading. Please note that the warranty wi...
Description orchestra.
Description orchestra reference.
Installation instructions read this carefully. Optimum listening quality is obtained when the following recommendations have been observed step by step. 1 - each orchestra is packed with its own tested tubes. Place the tubes: be careful do not mix up the tubes and place them immediately on to their ...
Tube position first of all, remove the grid which protects the tube sockets (be sure the mains connector is unplugged). Warning: for mounting the tubes, do not force them, this may damage the sockets. Be careful at dressing power tubes because they have stop pins on the central parts of the mounting...
How to turn on your amplifier in order to get the best performance from your jadis amplifier, it is necessary to follow carefully the instructions below: 1- check that the power switch is set to off. 2 - connect the loudspeaker wires to the red and black terminals at the back of the amplifier. 3 - c...
Maintenance your jadis amplifier is adjusted for a nominal voltage corresponding to your country's electrical network. If the amplifier fails to operate: 1 - turn off the unit immediately. 2 - unplug all the cables. 3 - do not forget the mains cord. 4 - contact your jadis dealer for diagnostic and r...
Orchestra specifications load impedance: 1 to 16 ohms output power at 1khz: 40 watts rms / channel bandwidth at -3 db: 5 hz to 60 khz sensitivity for nominal output power: 250 mv rms input impedance: > 100k ohms maximum power consumption: 300 w dimensions: 53 x 27 x 20 cm weight: 20 kg subject to mo...
