21 t able of contents introduction 25 accuracy 26 water resistance 27 "1000 hours control" test 28 adjusting the bracelet 29-32 use 34-36.
25 introduction we congratulate you on the purchase of your jaeger-lecoultre watch and thank you for your confi dence. The sublime beauty of the secret rock-setting technique, perfected by jaeger-lecoultre, allows the brilliance of the precious stones to shine through without revealing even a glimps...
26 accuracy mechanical models with manual or automatic winding the precision of the mechanical models is determined by the balance. The latter performs 21,600 or 28,800 vibrations per hour depending on the model (see technical characteristics). Despite all the care that the jaeger-lecoultre master- ...
27 water resistance jaeger-lecoultre reverso watches are water-resistant to 3 atm. This property is identifi able by the symbol engraved on the case-back. This means that your timepiece has been tested at an immersion pressure corresponding to 30 metres. You can use your watch while swimming or divi...
28 the "1000 hours control" test by jaeger-lecoultre jaeger-lecoultre subjects its watches to the rigorous "1000 hours control" test programme. Unique in its kind, this test consists of 1000 hours of comprehensive, stringent checks. The "1000 hours control" seal or marking, affi xed or engraved on t...
29 adjusting the bracelet you can adjust your steel bracelet yourself. However, if you have a gold model, we advise you to entrust it to the near- est approved jaeger-lecoultre retailer, or to contact one of our offi cial service centres listed at the end of the guarantee booklet. Adjusting the stee...
30 proceed in the same way for the following link (fi g. 3) if you want to remove a single row of links (or the 2 nd , 3 rd , etc. If you want to remove 2, 3... Rows of links). Take out the two bars (fi g. 4). Remove the row(s) of links (fi g. 5). Place the 2 ends of the bracelet back together and i...
31 adjusting the clasp the clasp of your watch is fi tted with a length-change system enabling you to lengthen or shorten your bracelet by 4 mm on each side, for enhanced wearer comfort. Using the fi ne adjustment system transition from the long position to the short position: remove your watch. Hol...
32 lift up the clasp cover so as to release the tip- over part of the bracelet section from its groove (fi g. 2) . Fig. 2 long position push the tip-over part of your bracelet section and place it in its groove, facing the opposite way to its initial position (fi g. 3) . Fig. 3 shortened position th...
34 technical characteristics - manually-wound mechanical movement, calibre 822. - 21,600 vibrations/hour. - power reserve : approximately 45 hours. - accuracy adjusted and tested in 5 positions. Movement jaeger-lecoultre calibre 822..
35 1 hour hand 2 minute hand 3 crown 1 2 3.
36 use winding crown in position 1. Winding is performed by turning the crown clockwise. The watch is fully wound when the crown locks. Do not attempt to wind a manually-wound watch beyond the locking point. To ensure good operating accuracy, it is advisable to wind your watch regularly, at least on...
