1. DL manuals
  2. Jag
  3. Grill
  4. Grill
  5. Owner's Manual

Jag Grill Owner's Manual

Summary of Grill

  • Page 1

    Warning: for outdoor use only warning: if the information in this manual is not followed exactly, an uncontrolled fire may result, causing property damage, personal injury or loss of life. Www.Jaggrill.Com the jag grill owner’s manual 1 form #006310 rev. 1.

  • Page 2: Introduction

    Introduction overview this manual details the assembly, operation, and maintenance for the jag grill firepit. Important service information no other jag grill firepit has the same serial number as yours. The serial number is on the inside of the side door attached to the firepit . This serial number...

  • Page 3

    General usage  keep the firepit clean and free of leaves and debris to ensure safe operation. Do not operate the firepit without first ensuring it is clean.  keep a portable fire extinguisher or other approved extinguishing equipment, such as a garden hose, readily available when operating this fi...

  • Page 4

    Assembly standard operation procedure placement requirements ! For outdoor use only. Install only in well-ventilated areas. Do not locate the firepit:  in high traffic areas  under or near trees, plants and buildings where debris may constantly fall into the firepit. Excessive debris will require ...

  • Page 5

    Parts list description part number qty item 1/4-20 x 5/8" hex drive button hd cap screw 001466 16 a 1/4 flat washer 001154 16 b 1/4 - 20 hex nut 001202 18 c 3/8-16 x 3/4" hex bolt 001020 32 d 3/8 flat washer 001156 32 e 3/8 lock washer 001174 32 f 5/16-18 x 3/4" hex drive button hd cap screw 001467 ...

  • Page 6

    A b c d e f g h i j l k m n o p r s t u 0.344 v 0.531 w 0.344 x y z aa 4 3 1 2 ac ab color and size are not representative of actual part. 6 form #006310 rev. 1.

  • Page 7

    7/16" wrench 1/2" wrench 9/16" wrench 5/8" wrench 3/4" wrench #2 square (robertson) drive 5/32" allen wrench 3/16" allen wrench 3/8" allen wrench tools required 7 form #006310 rev. 1.

  • Page 8

    G h i 1/2" wrench 3/16" allenwrench t 4 .344 .344 x .532 .344 .344 x .532 .547 .344 h 12 i 12 g 12 assemble four floor plates (t) loosley with three 5/16-18 x 3/4 button hd bolts (g), three 5/16 flat washers (h) and three 5/16 nuts (i) into each as shown. Tighten all hardware. Caution: proper assemb...

  • Page 9

    G h i 3/16" allenwrench 1/2" wrench w 3rd v 6th u 7th v 2nd v 4th u 5th v 8th u 1st assemble side plate (u) to floor plates loosely with two 5/16-18 x 3/4 button hd bolts (g), two 5/16 flatwashers (h) and two 5/16 nuts (i). Assemble leg plate (v) to floor plates and side plate (u) loosely with four ...

  • Page 10

    C 7/16" wrench assemble stove handle (q) onto door handle (x). Assemble door handle to fire pit door with two 1/4 nuts (c) and latch (y) as shown. X q y c 2 10 form #006310 rev. 1.

  • Page 11

    J l k m 3/4" wrench 1/2" wrench m 1 aa 1 assemble one 1/2-13 nut (m) onto one leveling mount (aa) and assemble to each leg (z). Repeat on remaining three legs keeping all heights the same. Once fire pit is on the ground adjust leveling mounts to level fire pit and tighten nuts to lock. Assemble leg ...

  • Page 12

    Caution: requires at least two adults to lift and set base on ground. Safely lift fire pit base and place on ground. 12 form #006310 rev. 1.

  • Page 13

    P d e f 9/16" wrench d 4 f 4 e 4 p 4 assemble four panel standoffs (p) to a side plate with four 3/8-16 x 3/4" screws (d), four 3/8" lock washers (f) and 3/8" flat washers (e) as shown. Repeat on all side plates. 8x 13 form #006310 rev. 1.

  • Page 14

    A b c 5/32" allen wrench 7/16" wrench r 1 b 1 c 1 a 1 assemble for each grill frame (r) loosely with two 1/4-20 x 5/8" button hd bolts (a), two 1/4" flatwashers (b) and two 1/4" nuts (c) as shown. Tighten all hardware. 14 form #006310 rev. 1.

  • Page 15

    Assembled grill frames (r). Place each grill (s) into place by sliding first one side into slot then sliding second side into the opposite slot. Repeat for all grills. S q s assemble one stove handle (q) onto each grill (s). Turn over and place assembled grill frames with tabs up onto base. 15 form ...

  • Page 16

    #2 square (robertson) drive o ac 1 ab 1 assemble tables by laying out the boards labeled (1), (2), (3) and (4) with pre-drilled holes facing up in the order shown. Place table bracket (ab) on boards and line up holes in hinge with holes in boards and screw in eight #8 x 5/8 pan head hex socket drive...

  • Page 17

    Swing grill up out of the way. Assemble each table by lining up and inserting all four large keyslot holes with panel standoff (p) slots, then press down to lock into place. Repeat for all tables. Wood maintenance: periodically reapply an oil finish to wood that appears dry to restore the beauty. Al...

  • Page 18

    Parts list description part number qty item frame assembly 2201-103586 1 ad top screen 2201-103592 1 ae handle bracket 2201-103593 4 af clamp strip 2201-103595 8 ag stove handle, dome 2201-103594 4 ah 3/8-16 x 6-1/2 cb 001468 4 ai 3/8-16 high crown cap nut 001469 4 aj 1/4 helical spring lock washers...

  • Page 19

    A ak c 5/32" allen wrench 7/16" wrench assemble handle assembly with two 1/4 x 5/8" button hd bolts (a), two 1/4 lockwashers (ak) and two 1/4 nuts (c) to fire screen. Repeat with remaining handle assemblies on opposite sides as shown. Handle assembly a 2 c 2 ak 2 19 form #006310 rev. 1.

  • Page 20: Operating Instructions

    Operating instructions ! Remove any cover from the firepit prior to operation. ! Inspect the firepit to make sure it is free of debris or objects that may have fallen into the firepit prior to operation . Start your firepit as follows: 1. Place charcoal and/or wood in the center of the firepit. 2. U...

  • Page 21

    Conditions & exclusions warranty 1. This firepit must be installed as per assembly sop. It must be installed, operated, and maintained at all times in accordance with the instructions in the owner’s manual. Any alteration, willful abuse, accident, neglect, alteration, misapplication or misuse of the...

  • Page 22

    If warranty service is needed: 1. If you discover a problem that you believe is covered by this warranty, you must report it to your jag grill dealer within 30 days, giving them proof of purchase, the purchase date, and serial number. 2. The jag grill has the option of either repairing or replacing ...