Jaga BRIZA 038 Installation Instructions Manual - page 5
5
BRIZA EC
E /
27200.23700029
- 7 september 2016 3:49 PM - Jaga N.V.
Mounting dimentions Built-In Ceiling
Acoustic isolation
Respect the free space around the unit as shown:
Insulation against airborne noise
Sound is reflected by hard materials. Soft, porous substances are
best suited to absorbing airborne sound.
Contact sound insulation
Sound travels very easily in hard materials. Contact sound insula-
tion will largely depend on this:
A. Quality of the placement<
Contact points:
• make sure that sound- and/or mechanical vibrations cannot be
transferred between different elements, e.g. between the built-in
heaters and a metal carrier, through pipes, along air ducts etc.
Hollow acoustic spaces:
• where air can travel, so can sound. Isolate the built-in heaters
in hollow acoustic spaces. Avoid cavities between insulation and
pipes. These form small resonance boxes. Avoid cavities along air
ducts (the acoustic effect cannot be predicted for this).
≥15
≥15
max. 230 cm
max. 230 cm
≥15
≥15
Mounting dimentions Built-In Wall
ATTENTION
≥10
≥15
≥15 ≥15
The unit must remain accessible for maintenance
Free spaces and installation:
IMPORTANT!
Incorrect positioning or installation of the unit may
amplify noise levels and vibrations generated during
operation.