JAKKS Pacific SPYNET User Manual
2.17.2010
SPYNET NV_ INST
©2010
2.17.2010
SPYNET NV_ INST
©2010
PMS 307 C & Black
1
4
Thanks for purchasing a great JAKKS Pacific® product!
Please immediately register your product online at www.jakks.com/warranty.
Registration is not required for the effectiveness of this limited warranty.
IMPORTANT NOTICE TO CONSUMER:
This 90 DAY LIMITED WARRANTY applies to the original product purchaser, provided the
product: 1) was purchased from an authorized JAKKS™ distributor/dealer/retailer, and 2) is
returned at your expense, postage pre-paid and insured, along with the original dated sales
receipt to the address noted below. Please save a copy of your original sales receipt, as the
original receipt will not be returned to you. If you return the product to us without the
original dated sales receipt, this warranty coverage will not apply. If the product is
determined by JAKKS to be defective and returned to JAKKS within the 90 day warranty
period, we will (at our option) repair or replace it. Return shipment to you may take up to 6
weeks, depending upon your location. If your product is repaired or replaced, it will be
warranted for the longer of the original warranty or for 30 days after warranty service.
SCOPE OF LIMITED WARRANTY: The product is warranted to be: a) tested and inspected
before shipment, and b) free of defects in material and workmanship for 90 days from date
of purchase. If a covered defect occurs within the warranty period, then at our sole option,
we will repair or replace the product or provide you with another product of equal value.
WHAT IS NOT COVERED BY LIMITED WARRANTY: THIS WARRANTY IS VOID IF THE
PRODUCT HAS BEEN MODIFIED OR REPAIRED BY USER OR OTHERS OR IF IT HAS
BEEN DAMAGED AS A RESULT OF ACCIDENT, IMMERSION IN WATER, NEGLECT,
ABUSE, MISUSE, BATTERY LEAKAGE, IMPROPER BATTERY INSTALLATION,
UNAUTHORIZED SERVICE, LOSS OF PARTS, WEATHER, ACTS OF GOD, ANY ACTION OR
OMISSION WHICH CONSTITUTES A DEVIATION FROM THE OPERATING INSTRUCTIONS,
OR ANY OTHER CAUSES NOT ARISING OUT OF DEFECTS IN WORKMANSHIP OR
MATERIALS. EXCLUSIONS FROM LIMITED WARRANTY: THIS WARRANTY IS EXCLUSIVE
OF AND IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES RELATED TO THIS
PRODUCT, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. SPECIAL, INCIDENTAL AND CONSEQUENTIAL DAMAGES
ARISING FROM POSSESSION, USE, OR MALFUNCTION OF THIS PRODUCT ARE
EXCLUDED BOTH FOR PROPERTY DAMAGE AND PERSONAL INJURY TO THE EXTENT
LEGALLY PERMITTED.
ADDITIONAL LEGAL RIGHTS: This warranty provides specific legal rights. You may have
other or different rights in your state or country.
QUESTIONS OR COMMENTS: If you experience product difficulties or have questions or
comments, you may contact our Consumer Relations department as follows:
Phone: 877-875-2557 (toll-free, North America only) or 909-594-7771 x560 (Monday-
Friday, 7:30AM-4:30PM Pacific/GMT -8).
Mail: JAKKS Consumer Relations, 21749 Baker Parkway, Walnut, California USA 91789.
Email: consumers@jakks.com
WHEN WRITING TO US: Please include: 1) product name; 2) item number; 3) purchase
date; 4) description of the problem being experienced; and 5) your name, address and
phone number. Additionally, if eligible under the warranty and so advised by JAKKS
Consumer Relations, also include the defective product and the ORIGINAL dated sales
receipt evidencing product purchase. Please retain a copy of your receipt.
080309
TM & © 2010 JAKKS Pacific, Inc., Malibu, CA 90265 USA.
JAKKS Pacific UK Ltd, Ascot, Berkshire SL5 9ED U.K.
MADE IN CHINA.
Contents may vary in style, color, shape and decoration from images shown on package or
in advertising. Questions or comments? www.jakks.com, consumers@jakks.com,
1-877-875-2557 in North America, or 01344 638909 in the United Kingdom.
US Pat #7,064,327. Licensed from Optikos Corp by its agent, RoyaltyPros Licensing.
JAKKS Pacific® Battery, Solar or Electrically-Operated Product
90 DAY LIMITED WARRANTY
Not Included
4 AA’s Required
1
4
Not Included
ADULT SUPERVISION REQUIRED.
See enclosed safety instructions.
8
PLAY RESPONSIBLY.
RESPECT OTHERS’ PRIVACY
AND ALL LAWS.
FOR SET-UP: (
ADULT INSTALLATION REQUIRED)
Requires 4 AA (LR06) alkaline battery
(not included)
Battery installation:
Locate the battery
compartment underneath the unit. Using a Phillips
screwdriver, remove the screw and the
battery door. Install a fresh battery,
matching polarity icons with those on the
unit. Replace the battery compartment
and the screw.
When operating in environments that
are subject to electrostatic discharges,
the SpyNet
™
Night Vision Binoculars
may malfunction. If this occurs, the user
should reset the unit by using the
on/off switch.
PAGE
[
6
]
PAGE
[
1
]
ADULT SUPERVISION REQUIRED.
See enclosed safety instructions.
8
GEAR UP WITH THE SPYNET™
NIGHT VISION INFRARED
STEALTH BINOCULARS
NIGHT VISION BINOCULARS DIAGRAM
1.5V “AA”, R6P
1.5V “AA”, R6P
1.5V “AA”, R6P
1.5V “AA”, R6P
WARNING: Battery acid leakage can cause personal injury and cause damage to the product and surrounding property.
If battery leakage occurs, thoroughly wash any affected skin, making sure to keep battery acid away from eyes, ears, nose
and mouth. Immediately wash any clothing or other surface that comes into contact with leaked battery acid. Leaking
batteries may make “popping” sounds. Dispose according to Local, State and Federal Laws.
TO AVOID BATTERY PROBLEMS:
Do not mix old and new batteries.
Do not use rechargeable batteries.
Never mix alkaline, standard (Carbon-Zinc) and rechargeable (Nickel-Cadmium) batteries.
Only batteries of the same or equivalent type as recommended are to be used.
Batteries are to be inserted with the correct polarity.
Exhausted batteries are to be removed from the toy.
The supply terminals are not to be short-circuited.
Different types of batteries or new and used batteries are not to be mixed.
Non-rechargeable batteries are not to be recharged.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
IMPORTANT SAFETY INFORMATION BATTERY WARNINGS AND PROPER USE
3D SPY CARD
Unlock secret content with augmented reality technology.
MINIMUM OPERATING SPECS
High Speed Internet Access and USB or built-in Web Camera (640x480 or 320x240)
PC
MAC
IE 6, or Firefox 2.0
Safari 2.0
Windows Vista/XP
Tiger or later (Leopard/Snow
1 GB Ram
Leopard)
Pentium 4 Processor
1 GB Ram
Audio Card for Sound
TO USE YOUR 3D SPY CARDS
1) Click on the
3D Cards
tab on the SpyNet™ HQ Website (www.SpyNetHQ.com).
2) On the 3D Cards page, select your card’s toy icon from the list.
3) After the page loads, you should see the camera view from your webcam onscreen.
4) Hold your 3D Spy Card up about 6-12 inches (15-30 centimeters) from your
webcam, making sure that the entire face of the card can be seen onscreen.
5) You’ll then see a 3D model of your toy appear onscreen. Cover the button with
your finger to have information windows about the toy pop up onscreen. Cover the
button with your finger to cycle to another 3D toy model.
HOLD 3D SPY CARD APPROXIMATELY ~ 6-12 INCHES/15-30 CENTIMETERS FROM WEBCAM
Item No.:
Description:
Color(s):
Dimension (Width x Height x Depth):
Primary Display Panel (PDP) Size:
Product Line:
Studio:
Customer:
Vendor:
IS
SpyNet
In House/Kalok
11” x 8.5” x 4
18738
Night Vision
Version:
US
Revision:
00
Minimum Packaging Spec.:-
Coating:
PMS 307C & Black
LIFT
LENS
COVER
before
operating
LIFT
LENS
COVER
before
operating