Sonic d user guide.
1 introduction unpacking & important safety instructions suggested applications sonic - d series operation instructions sonic - mx series operation instructions different cleaning methods 3 3 3-4 5 6 7-8 9 10-11 12.
Introduction ultrasonic cleaners function by producing sound waves that are transmitted into the tank and cleaning solution. These waves create millions of microscopic bubbles, which collapse or ‘implode’, releasing large amounts of energy, which scrub the surface clean. This process is called ‘cavi...
Domestic jewellery: necklaces, rings, bracelets, etc. Watches: waterproof wristwatches, watch chains. Toiletry items: electric toothbrush heads, electric shaver heads, razor blades, combs, toothbrushes, dentures etc. Office equipment: printer heads, fountain pen nibs, wax or rubber stamps etc. Metal ...
Sonic d series operation instructions 1) check the specification table for the correct operating requirements (located on the rear of the unit). 2) before connecting power, put the unit on a stable and flat working surface. Add water to tank, sufficient to completely immerse the items being cleaned. ...
5) setting the timer– when power is on, the timing setting figure will flash once the option button has been pressed. This indicates that a time setting is required. To set the timer, press the button to set the required cleaning time (minutes). The ultrasonic's cleaning function will instantly star...
Operation instructions 1) check the specification table for the correct operating requirements (located on the rear of the unit). 2) before connecting power, put the unit on a stable and flat working surface. Add water to tank, sufficient to completely immerse the items being cleaned. Using the stain...
1) general cleaning: only use plain warm water, about 50°c. 2) enhanced cleaning: add a few drops of standard washing up liquid, liquid soap, or detergent into the water, other non-acidic based cleaning agents can be also used. 3) extensive cleaning: removing tarnish, carbon and rust from non-plated...
