JAMO Amplifier AT101 Instructions - Introduction

Introduction

The Jamo AT-101 Audio Stereo Attenuator with automatch can be

used as a volume control for up to 64 pairs of speakers.

PLACEMENT

The AT-101 should not be located close to light switches/dimmers

as this may cause a hum in the speakers. If the AT-101 is located

close to these devices it must be mounted in a separatly grounded

electrical box. Speaker cables/wires should also be as far away from

electrical wires as possible.

INSTALLATION

The amplifier must be turned OFF before you install the AT-101 and/

or speakers or it may cause damage to the amplifier.

When connecting speaker cables/wires from the amplifier to the

AT-101 and from the AT-101 to the speakers make sure LEFT (L) is

connected to LEFT (L), RIGHT (R) to RIGHT (R), POSITIVE (+) to POSI-

TIVE (+) and NEGATIVE (-) to NEGATIVE (-). If terminals are colour

coded, RED is POSITIVE (+) and BLACK is NEGATIVE (-). For installa-

tion of more than 1 pair of speakers see „Impedance matching“.

SET-UP

Before turning on the amplifier turn the amplifier volume to mini-

mum. Turn the AT-101(s) to maximum volume (clockwise). Turn the

amplifier on and slowly turn up the volume to the highest desired

level without distortion from the speakers.

The volume of all speakers are now controlled by the AT-101(s) and

the amplifier volume control should not be used.