Janam xt series Quick Start Manual - page 10
XT Series Quick Start Guide
Page 9
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorientorrelocatethereceivingantenna.
•Increasetheseparationbetweentheequipmentandreceiver.
•Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
•Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
If necessary, the user should consult the dealer or an experienced radio/television technician for additional
suggestions.Theusermayfindthefollowingbooklethelpful:“SomethingaboutInterference.”Thisisavailable
atFCClocalregionaloffices.Ourcompanyisnotresponsibleforanyradioortelevisioninterferencecausedby
unauthorizedmodificationsofthisequipmentorthesubstitutionorattachmentofconnectivecablesandequipment
otherthanthosespecifiedbyourcompany.Thecorrectionistheresponsibilityoftheuser.Useonlyshieldeddata
cables with this system.
This device and its antenna must not be co-located or operating in conjunction with any other antenna or
transmitter. To maintain compliance with the FCC RF exposure guidelines for body-worn operation, do not use
accessoriesthatcontainmetalliccomponentsotherthanspecifiedbythemanufacturer.